This bridle black medium Skinny MoneyMaker 3-Camera Harness from HoldFast Gear has a width of one inch and features removable shoulder pads. The D-rings are removable as well, so you can decide to keep them or remove them. The MoneyMaker is made from U.S. native steer hides, with anchored, rust-resistant, stainless steel D-rings and hardware, plus safety straps for ultimate security. The versatile design makes this harness an essential tool for the modern photographer.

The bottom side of the harness strap has a suede-like feel, and will shed a little at first use. Running your hand along the length of the strap will remove most of the loose shavings. The bottom side is also colorless, so it won't bleed onto your clothing.

HoldFast Gear uses real full grain leathers. As such, your harness may display the unique life that the animal lived, including scars from brands, barbed-wire cuts, stretch marks, insect bites, birthing marks, and natural creases.

Securely Holds 1-3 Cameras    Made from U.S. Native Steer Hides    Stainless Steel D-Rings and Hardware    Hardware is Rust Resistant    Removable 1.5" Wide Shoulder Pads    Holds Other Gear and Accessories

The Skinny MoneyMaker is 1" wide and has 1.5" wide shoulder pads.

Fit is based on height and broadness. The ideal carrying position of the MoneyMaker is for the strap to fall about 4" below the armpit so the cameras stay high on the body.

Small: Height of 5'7" and below; if you are broad/built, size up

Medium: Height between 5'8-6'2"; if you are slender, size down, broad or built, size up

Large: Height of 6'3" and above or wear extra-large clothing

Ideally, you want the straps of the MoneyMaker to fall about 4-5" below your armpits. Optimum fit will ensure the most comfort long term. If the MoneyMaker is worn too loose it causes the cameras to swing and sway too much, which puts pressure on your lower back while the straps will tend to move and slip more. When worn properly, the MoneyMaker is anchored to the body and actually helps to correct poor shooting posture by pulling your shoulders upright and back, keeping you and your cameras in line. When the main straps are around 4" below your armpit area, this will place the clip that attaches to the camera right around your waist line. So, there should be a good amount of arm bend when your hand is on the camera at resting position.

Related Questions and Answers

Q: 1. Does this model of the Money Maker have the new slide mechanism like on Holdfast's website? Or is it the older round sliders?

A: Yes this model has the most current slide mechanism.

Q: 2. Is HoldFast Gear The Camera Holdfast Accessory Clip (Quick Release Plate Compatible) included with the Money Maker original?

A: Yes, it comes with 2 clips as stated in whats in the box; In the Box HoldFast Gear Money Maker 2-Camera Buffalo Leather Harness (Tan, Small) 2 x HoldFast Gear The Camera Holdfast Accessory Clip 2 x Camera Leash Limited Lifetime Warranty

Q: 3. How easy is it to take the camera off the clip?

A: I find it's a two handed job that I prefer to do sitting, just in case the camera slips out of my hand. Not incredibly difficult though. But definitely secure enough to keep your cameras on there with the main clip and the safety fabric loop. I usually take my camera off for family formals during a wedding, and when we're sitting down to eat, but other than that I keep them on.

Q: 4. Could this hold a Sony A9 with the new 200-600 lens?

A: This harness can accommodate a A9 with a Sony FE 200-600mm lens attached using the tripod collar of the lens. However, we recommend supporting the lens by hand whenever possible due to the length of the barrel.

Q: 5. His do you have the buffalo leather holdfast harness in a burgundy ? That’s for the water buffalo leather

A: I'm sorry, no, we don't have this model in burgundy.

Q: 6. Hello I have a question it si possible to remove the straps an from of the harness money maker 3 gear?

A: It is not possible to dissemble these straps. This adds to your piece mind knowing it will not fall apart on you.

Q: 7. If you buy the Two-Camera Swagg Harness, can you buy something to turn it into a Three-Camera harness?

A: You can buy 3 camera holster , HoldFast Gear MoneyMaker Three-Camera Swagg Harness (Copper, Cotton Canvas) BH #HOCS03CO3

Q: 8. Could anyone tell me what size would be good for a 5'4 tall guy? There is no sizing information and I would really like one Thanks

A: I think medium would be perfect for you

Q: 9. Will I need any additional gear to take camera off harness and then mount my camera to a tripod?

A: No.

Q: 10. Can I get this without the d rings?

A: If you order directly through the manufacturer website you can.