The Laird 12" Power Cable from TecNec features a 2-pin LEMO connector at one end and a 2-wire flying leads end at the other. This can be used to power many Teradek devices.

Two-wire flying leads end

Works with Bolt, Bond, Link, and many Cubes

Laird Equivalent for Teradek BIT-218 cables

Related Questions and Answers

Q: 1. Does this work with the AUX 2-pin LEMO on DSMC2 cameras?

A: Unfortunately, there is no way for us to test this, not any manufacturer we could ask. That being said, if the jack on the particular RED camera is 2-pin, it probably will work. Do not use without checking the polarity first. And as a last reminder, such use is unsupported meaning if anything goes wrong, the manufacturers with not repair under warranty.

Q: 2. Would this work as a power supply on a ZCam E2 S6?

A: Yes, the Teradek 2-Pin LEMO to AC Adapter Cable (6 ft) is compatible with the Z CAM E2-S6 Super 35 6K Cinema Camera (EF Mount) since the Teradek and Z Cam share the same pin 1 as ground.

Q: 3. Does this work with the MDR.X

A: No, The Teradek 3-Pin to 3-Pin R/S Power Cable for MDR.S Receiver does not work with the MDR.X.

Q: 4. What size is the barrel end?

A: The barrel end is a 5.5x2.1mm, center-positive barrel jack.

Q: 5. is this same as teradek bolt 2 pin cable?

A: Yes. will work just fine. Just be mindful that the cable has a RA 4-Pin Hirose on the other end.

Q: 6. This should be included in every Bond or Cube device, isn't it? Do I need to buy this separatelly to operate BOnd/Cube without battery? AC I mean

A: If you wish to use the Bond or Cube on AC only, yes this is what you need. Because everyone's needs are different, manufacturers offer some accessories as options. Thus people who only use batteries are not stuck with AC power adapters they do not use nor are people who only use AC get batteries that clutter up their closets.

Q: 7. Purchased this for Bolt 1000 Transmitter/Receiver. What I received was a power supply with a 12V/3A output. Is this the right part?? My original is 9.0V/2A. I don't want to fry anything.

A: This is a power cable created by Teradek specifically for their Cube, Bolt, Bond and Link products. It should work just fine with your Bolt 1000.

Q: 8. Can this work to power the Small HD cine7 monitor? I see someone has asked about indie7 but just wanted to check. I know they list it as for something teradek cube, etc. but what makes it different that it wouldn't work on the cine7?

A: This cable can power the SmallHD Cine 7 monitor. 2-pin LEMO cables are cross compatible with different brands that have a 2-pin LEMO port.

Q: 9. what size of the LEMO is this? B1 or B2

A: That is not listed as this cable is specifically for the 2-pin LEMO versions of the Teradek Cube, Bolt, Bond and Link products.

Q: 10. Can you use this cable to power a teradek bolt 500 xt and teradek bolt 500 HDMI Lt? Or do you have to use the cable that teradek makes?

A: yes this cable can be used to power the Teradek Bolt 300/500/600/Sidekick II