The ANDYCINE Multifunctional Ball Head has a unique 1/4"-20 and cold shoe double mount that supports and stabilizes equipment weighing up to 6.6 lb while providing 90° vertical tilt for precise orientation.

The ball head mount is double-sided and can be flipped for a cold shoe connection on one side and a 1/4"-20 male connection on the other. The head connects to the tripod legs with a 1/4"-20 female connection on the bottom. Lock in the precise orientation with the adjustable knob thumb lever screw, located on the side along with a NATO rail mount and a 3/8"-16 thread with an ARRI locating hole. The bottom of the head is compatible with a 38mm Arca-type quick release plate and is protected from scratches by PVC rubber padding.

1/4"-20 / Cold Shoe Double Mount    Supports 6.6 lb Load    90° Vertical Tilt    NATO Rail Mount    3/8"-16 Thread with ARRI Locating Hole    Compatible with 38mm Arca-Type Plates    PVC Rubber Padding Prevents Scratches

Related Questions and Answers

Q: 1. In the photos, a block on the opposite side from the thumbscrew looks as if it might have a threaded hole. Is it a 3/8 socket?

A: Yes, the ANDYCINE Multifunctional Ball Head has a 3/8" hole with Arri locating screws on the side.

Q: 2. Hello, is the Induro BHD2 Ball Head compatible with the Induro AKP2 Tripod?

A: Yes, you can put this ballhead on virtually any tripod.

Q: 3. Could this hold a DSLR (Canon M50 Mk ii) at a 90 degree angle?

A: The SmallRig 2164 Multifunctional Crab Clamp with 3.5" Ball Head Arm has a maximum payload of 2.2 lb / 1 kg. The Canon EOS M50 Mark II Mirrorless Digital Camera with 15-45mm weighs 1.1398 lb / 517 g. You will be good for stationary positioning even at 90°.

Q: 4. Hi:What is the difference between the Sirui G20X and G20KX?Thanks

A: The Sirui G20X and G20KX are the same ball head.

Q: 5. can this head accept any Arca Swiss type plates? I alrady have this balls head, and it works with most of my cameras except one, Mamiya RZ67, it just won't secure. So I'll need to buy the three point lock arca swiis type for that camera, but I wonder if it will fit this head?

A: I use the Sirui TY-60 Arca type plate with this head and it works well with. my 65mm Pentax spotting scope.

Q: 6. I've got an L bracket on my Canon 5d iii, what plate would I use with this setup?

A: You can use the included quick release plate with the Canon 5D Mark III and L bracket.

Q: 7. What is the diameter of the ball on this head?

A: The diameter of the SmallRig 2164 Multifunctional Crab Clamp with 3.5" Ball Head Arm's ball section is 1.5".

Q: 8. Can screw this into a tripod?

A: No, this is designed to go into a cold shoe.

Q: 9. Is this ball head compatible with a Gitzo GT2542T Series 2 Traveler Tripod?

A: Both Gitzo and Sirui heads and tripods use a 1/4-20 thread screw mount so I would say the answer is Yes .

Q: 10. I bought this piece already, considering getting another arm, will 2 arms sit next to each other without problems? Seem like they would

A: Otherwise, having two of these arms next to each other should be fine.