The 16mm Light Stand Head with 5/8"-11 Male to 1/4"-20 Female Thread Screw from CAMVATE comprises an aluminum light stand head and a 5/8"-11 male to 1/4"-20 female thread screw for use with a tripod laser level Bosch adapter. The supplied head adapter fits into a pole/rod with a maximum 16mm column diameter and is fastened by a locking knob.

Light Stand Head with 16mm Diameter    Directly Fits into Light Stand Rod    5/8"-11 Male to 1/4"-20 Female Screw    For Tripod Laser Level Bosch Adapter    Aluminum Construction

Related Questions and Answers

Q: 1. What is the thread depth of each side?

A: Manfrotto 119 Short (16mm) Adapter Spigot with 1/4"-20 & 3/8" Female Threads has a pass through thread. The 3/8-16 is 24mm deep while the 1/4-20 is 9mm.

Q: 2. is the lens compatible with Nikon D7000 camera?

A: Yes, Tokina atx-i 11-16mm f/2.8 CF Lens for Nikon F BH #TO111628CFN is compatible with the Nikon D7000.

Q: 3. So what is the intended purpose of the hole in the middle?

A: In some situations you can line it up with the set screw and then you won't have rotation of the stud in the mount.

Q: 4. does it has focus hard stops ? and how much is the focus throw? i want to use it with blackmagic 6k

A: Yes, the atx-i 11-16 has hard stops on minimum and infinity when set to MF via the clutch. Focus throw is quite short; approximately 75~85 degrees.

Q: 5. Can this be used with Nikon D200? Also, can this lens be used with Nikon bodies that do not support electronic aperture?

A: Yes, the Tokina atx-i 11-16mm f/2.8 CF Lens for Nikon F can be used on the Nikon D200 and can be used on DSLR cameras, and Mirrorless cameras with an adapter.

Q: 6. How bad is chromatic abbresation? Can be fixed during post processing?

A: That would depend on sensor and lens combination. The lens has an optical flaw of 25 micrometers which is noticeable to the naked eye not to say that this can not be fine turned in post.

Q: 7. Can be used with a Blackmagic Video Assist 7" First version?

A: The CAMVATE Monitor Holder C-Frame Cage with 5/8" Light Stand Receiver (B&H# CAC2426) will not fit the Blackmagic Design Video Assist 7" 12G-SDI/HDMI HDR Recording Monitor (B&H# BLVIDA127HRD).

Q: 8. Whats the size of the balls? Is it compatible with Ultra Light Arms?

A: The ball measurement is not provided by Tilta, regarding the Tilta Ball Head with 1/4"-20 Screw with Locating Pins for SmallHD Monitors.

Q: 9. does the front element rotate ?

A: This lens has internal focusing, so the front of the lens won't rotate while focusing.

Q: 10. I'm confused if this adapter fits on a typical light stand stud? What exact size is the stud it is designed for? Thank you.

A: Yes, this is a standard Junior/Baby Pin (standard light stand) to 3/8"-16 Screw.