This Double-Sided Quick Release Clamp from CAMVATE is capable of mounting two quick release plates on either side, thanks to its back-to-back configuration. A 1.5 to 1.7" clamping range makes it compatible with most quick release plates. An integrated 1/4"-20 screw attaches the plates and can be tightened with the included Allen key. Built-in bubble levels on each plate and the two clamp levers ensure your camera remains level and balanced.

Double-Sided Quick Release Mounts    1.5 to 1.7" Clamping Range    Integrated 1/4"-20 Screw, Allen Key    Built-In Bubble Levels

Related Questions and Answers

Q: 1. Is this clamp Arca Swiss compatible and able to work on an RSS Arca Swiss L-plate?

A: Simply....YES.

Q: 2. I want to put this on top of the FEISOL PB-70 Panning Base, then fasten the whole thing to a Desmond DNR-180 Nodal Rail, and use the whole thing as the upper rail for a cheap panoramic solution. Will it even work, considering thread size and overall durability?

A: Yes , if one uses the reducer bushing :https://bhpho.to/2gGw2Pp on top of the Feisol PB-70 panning base, one can mount the Desmond DAC-38 Quick Release Clamp with a 1/4"-20 inner thread below..

Q: 3. Is the knob on the side the same height as the clamp? Could the knob be adjusted while mounted flush to a table?

A: Knob is lower than the clamp. the clamp would need to be elevated for the knob to turn and for the clamp to be level.

Q: 4. What is the gap distance of clamp at closed/opened position? I have 38mm wide arca-style base on 2 cameras. I want to know whether I can drop in camera, or I have to slide in from the side. Thank you.

A: It opens from 33mm to 38mm, you'll have to slide in your plate from the side.

Q: 5. Can the locking pin be removed?

A: The locking pin on the FLM QLB-80 Quick Release Clamp cannot be removed. However, if you squeeze the pin between a pair of pliers and push it down into the body of the clamp, the locking pin will be ineffective and out of the way.

Q: 6. Can the small plates for just a camera body be used with this long clamp?

A: Yes you can use a smaller plate.

Q: 7. How do you remove the safety pin?

A: Hi, the safety pin is not removable--it is spring-loaded and will retract into the body of the clamp if not in use.

Q: 8. Is this compatible with the Sirui P-204SR P Series Monopod?

A: Yes. The Sirui Quick Release Clamp will fit the P204SR monopod.

Q: 9. Is the Wimberley C-30 Quick Release Clamp compatable with the Induro PL-70 plate?

A: Yes the PL70 will work in the C30 clamp.

Q: 10. Will this work with Peak Design arcs plate for capture?

A: Yes it will.