The 2’ Laird Teradek Power Cable from TecNec features LEMO 2-pin male connector at one end and fischer 11-pin male connector on the other end. It is designed to connect the Teradek Cube X55 Encoder to industry cameras sources with 11-pin Fischer Accessory Power.

Cables fabricated with high quality components and are 100% continuity tested

Related Questions and Answers

Q: 1. Is this the connector that has 2 female receptors and 1 male pin?

A: No, the ARRI 24V, 3-Pin Fischer-Type Male to 3-Pin Fischer-Type Female Power Cable (10") is a 3-pin Fischer-type male to 3-pin Fischer-type female power cable.

Q: 2. Can I use this on Mini LF to teardek Bolt TX?

A: Yes, the Tilta 2-Pin LEMO-Type to 3-Pin Fischer-Type Cable can be used with the 24-volt 3-pin Fischer output on the ARRI ALEXA Mini LF and Lens Mount Set (LPL) into the 2-pin power input on the Teradek Bolt 4K XT Transmitter.

Q: 3. This ok to use on Teradek Cube? Thankssss

A: Yes, this meant for most any Teradek device.

Q: 4. can you power the new SMALLHD INDIE 7 monitor with this cable?

A: No you can not. You should use this to power the Indie 7 Monitor instead. SmallHD D-Tap to L-Series Dummy Battery Cable (32") BH #SMDTSLFB • MFR #PWR-ADP-SONYL-DTAP

Q: 5. Is this adapter compatible with the JVC GY-HM660U? If not could someone point me in the right direction to power a teradek bolt 500 LT on the camera end? I need power to the reciver on the camera, The receiver end is powered via 2 Pin Lemo

A: It is not. The HM660U does not have an external power output to connect with this cable.

Q: 6. Does this work with the AUX 2-pin LEMO on DSMC2 cameras?

A: Unfortunately, there is no way for us to test this, not any manufacturer we could ask. That being said, if the jack on the particular RED camera is 2-pin, it probably will work. Do not use without checking the polarity first. And as a last reminder, such use is unsupported meaning if anything goes wrong, the manufacturers with not repair under warranty.

Q: 7. Is this cable shielded?

A: The Tilta 2-Pin LEMO-Type to 3-Pin Fischer-Type Cable is not a shielded cable.

Q: 8. This should be included in every Bond or Cube device, isn't it? Do I need to buy this separatelly to operate BOnd/Cube without battery? AC I mean

A: If you wish to use the Bond or Cube on AC only, yes this is what you need. Because everyone's needs are different, manufacturers offer some accessories as options. Thus people who only use batteries are not stuck with AC power adapters they do not use nor are people who only use AC get batteries that clutter up their closets.

Q: 9. Purchased this for Bolt 1000 Transmitter/Receiver. What I received was a power supply with a 12V/3A output. Is this the right part?? My original is 9.0V/2A. I don't want to fry anything.

A: This is a power cable created by Teradek specifically for their Cube, Bolt, Bond and Link products. It should work just fine with your Bolt 1000.

Q: 10. What size is the barrel end?

A: The barrel end is a 5.5x2.1mm, center-positive barrel jack.