Add a remotely controllable high-definition ePTZ camera to your IP network at your education, remote meeting room, lecture hall, or house of worship location with this white EasyIP 30 ePTZ Camera from Vaddio. The EasyIP 30 installs onto your existing network and it streams up to 1080p60 high-definition video over aLAN to a network switch, video switch, recorder, and/or display.

The camera features IP control over the RJ45 LAN port using a web configuration interface, and it is also powered via PoE+ over the same RJ45 interface. Up to 16 presets can be assigned and managed via the included IR remote controller. Other features include a 20x optical zoom with a total of 30x zoom using digital IntelliZoom image processing.

A wall mount with mounting hardware is included with the camera, and the camera supports image flip so it can be installed right-side up or upside down.

1/2.5" Type Exmor R CMOS Sensor    70.2 to 3.1° FOV    20x Optical Zoom, 30x with IntelliZoom    IP Video Output & PoE+ Support    Stream up to 1080p30 Video    IR Remote & Telnet Control    Comes in White Color

An 8.51 MP, high-definition 1/2.5" Type Exmor R CMOS sensor delivers 1080p30 video

20x optical zoom extends to 30x zoom with digital IntelliZoom image technology

70.2 to 3.1° field of view

One EasyIP RJ45 Ethernet video output

Powered via PoE+ on a supported network

Plug and play with other Vaddio EasyIP collaboration endpoints

Advanced Intelligent Framing algorithms keep your participants in view

Related Questions and Answers

Q: 1. If trying to set the white balance from a flash, does this show a similar value to the flash temp (like around 5600K)?

A: The Manfrotto EzyBalance Gray Card is color neutral. If trying to get the correct white balance on a camera when using flash, this can give you the correct reading for a custom white balance. The reading itself is done in the camera or in software during post processing.

Q: 2. question about the joystick.the more I move the joystick to the sides/up/down, the more faster camera move? like the sony rmb300 joystick?or I must adjust the knobs to change the speed of the movement?

A: The joy stick is like any other, the farther you move it, the faster it goes. You regulate the top speed with the speed knobs.

Q: 3. will this do PoE from control ports to the camera?

A: no it will not you will need a POE switch

Q: 4. Is this compatible with Sony SRG-400 and the PTZ optics EPTZ cameras?

A: The Vaddio ProductionVIEW Precision Camera Control is not compatible with those cameras.

Q: 5. For an IP camera (AW HE140 or AW HE130) that runs on POE +, camera control and video out on a single Cat 5. Will this controller run the cameras if it is plugged into the router, or does each camera still need a separate cable ran to be ran to each camera port?

A: This controller needs a separate cable to each camera.

Q: 6. Can I verify that this does indeed work with and extend USB 3.2 Gen 1? Vaddio's site states USB 3.1 only for this part #.

A: You are correct, the Vaddio USB 3 Extenders will support up to USB 3.1, not USB 3.2 as it is currently labeled on our listing. We will correct the listing.

Q: 7. How long can I run the USB3.1 cable to this camera?

A: The USB cable that comes with the camera is 6 feet. You can extend that further with a high quality extender like the ATEN USB 3.1 Gen1 Extender Cable - 32.8' (BH #ATUE3310) but signal degradation may start to occur over some longer runs.

Q: 8. can this microphone work with a third party DSP? ie does it have a balanced audio output?

A: no this does not have a balanced audio output

Q: 9. Does the camera allow for POE via the ethernet port?

A: No POE for this camera.

Q: 10. How do I flip the image on the camera if it's ceiling mounted

A: In order to flip camera image go to back of PTZ camera base and locate the Camera Settings: DIP switches adjust the following features Ir remote frequency Baud rate Image flip