This LP-E12 Dummy Battery with USB Type-C Connector Kit from Bescor works with Canon cameras that use an LP-E12 battery. The dummy battery comes with a USB Type-C connector and cord. The device has external voltage regulation.

D-Tap Voltage Converter    Dummy Battery for USB Type-C Power Port    Battery and Charger Included    For Use with Select Canon Cameras

Related Questions and Answers

Q: 1. What is the Volts and Amperage outputs? Looking for something between 7.2-7.6 Volts and 2-3 Amperage

A: The Bescor Sony NP-FW50 Dummy Battery with USB Type-C Connector will output 7.2V at 1.02 amps.

Q: 2. Can you power the charger via usb? Or just charge from the unit via usb?

A: The USB port only provides power to other devices, it cannot be used to power the charging unit.

Q: 3. Is this compatible with the Panasonic GH6? The dummy battery in the picture is NOT the blk22.

A: Bescor has not listed yet what is compatible with the Bescor Panasonic Style DMWBK22 Dummy Battery with USB-C Input Connector Kit. Technically it should.

Q: 4. WIll this work on a NIkon D750 connecting it to a USB-C power bank, such as Anchor? Does it step up the 5 v power to 7 volt?

A: The Bescor EN-EL15/EP-5B Dummy Battery with USB Type-C Connector Kit is compatible with the D750, using a USB power bank.

Q: 5. Will this allow my camera to run while it's plugged in? I'm looking to leave it charging while I'm streaming

A: The GyroVu USB to Canon LP-E12 Dummy Battery Cable (40") doesn't charge the camera whatsoever, it is meant to power not charge, externally.

Q: 6. Will this work with the RP model?

A: No, the GyroVu D-Tap to Canon LP-E12 Dummy Battery (30") is not compatible with the Canon EOS RP. We recommend using the GyroVu D-Tap to Canon LP-E17 Dummy Battery (30")(BH #GYVDTAPLPE17) instead. See: https://bit.ly/3SWrdC4

Q: 7. How long would a 22000 mAh, 2.4 amp output power bank last when connected to a Canon EOS M50 used as a webcam or for streaming?

A: The time of power Canon M5o really depends on the mode it used for. We can't give you exact figure bu we can compare to standard Dea Michael, As we understood your power bank is 22,000 mAh, but usually this just a specification of the battery inside and electronics is eating at least 10-15% of the power bank capacity. So lets assume that it will put out 19,000 mAh. Our up-converting cable is using around 25% of the power to up-convert form 5V of power bank to 8V of LP-E12 dummy battery. So it will be around 18,250 mAh of useful power. The LP-E12 is around 900 mAh, so 18,250 divided by 900 - will be 15-16 times longer than regular LP-E12. This of coarse just rough estimation and will depend on quality and condition of the power bank. Just for your information we also are providing 30,000 mAh and 40,000 mAh power banks. Sincerely, Gyrovu Team.

Q: 8. If I don't have a D-Tap Source, Can I solder in a good 12v or 5v adapter on the D-Tap End and use this to power my camera directly for the wall?

A: We are not aware of that being possible with this product.

Q: 9. Will this work with the canon m50? I need the battery door to be closed though.

A: The GyroVu D-Tap to Canon LP-E12 Dummy Battery (30") will work with the Canon M50, but it would require that the battery door remain open or be removed entirely. Unfortunately since the M50 doesn't have a power input, using a dummy battery and keeping the battery door open is the only way to power the camera with an external power source.

Q: 10. does this need a battery adapter plate? or can i use it by itself?

A: This requires a battery adapter plate if you're using it for a camera battery. It comes with the plate for the LP-E12, and you can swap that piece out down the road for other battery plates.