This Quick Release NATO Safety Rail Set from CAMVATE is a pack of two rails measuring 2 and 3.9", respectively. Each rail has a safety pin on either end to prevent your NATO-compatible accessories from sliding off accidentally while mounted. Included 1/4"-20 mounting screws allow you to attach the rails to your camera cage.

2-Pack of NATO Rails    2 and 3.9" Lengths    Safety Pin on Each End    1/4"-20 Mounting Screws

Related Questions and Answers

Q: 1. if i get this, would I be able to use any sling handgrip that has a NATO clamp, such as the SmallRig Sling Handgrip for DJI RS ?

A: Yes, any possible adaptation with a NATO clamp can be used with the Niceyrig Gimbal Clamp with NATO Rail for Zhiyun-Tech CRANE 2S, there just needs to be proper clearance.

Q: 2. Does he go both side on Ronin S ?

A: The Ronin S is not compatible with the Tilta NATO Rail to Rosette Adapters. It is compatible with the Ronin RS 2. You can use the left or right side adapter on the opposite side of the gimbal but the gimbal body may interfere with the orientation of the locking levers.

Q: 3. Is the plate compatible with generation 1 receiver set?

A: Yes, it is compatible with the Claw QR receiver Gen 1.

Q: 4. What is the actual length of this rail? The specs say 18mm, but that must be referring to the width, as 18mm is a standard NATO rail width.

A: Tilta NATO Rail Attachment for Sony a7S III Cages is 49mm long, 21mm wide, and 8mm high.

Q: 5. What's an easy way to mount the bottom to a cheese plate switch 1/4-20" holes? (Without anything getting stuck)

A: A CAMVATE 1/4"-20 Stainless Steel Hex Screw Pack (20 Pieces), BH # CAC1956 would help you attach this Ulanzi Claw Quick Release Set onto a cheeseplate. https://bhpho.to/3kPJtP7

Q: 6. Will this work with the 1DX series

A: The CAMVATE Arca-Type Quick Release L-Plate for Small/Medium DSLR Cameras is too small for the Canon 1dx.

Q: 7. Is it operator left or looking at the camera left? Just being sure. Thanks.

A: Operator left. If you are using the gimbal it will mount on your left.

Q: 8. Is this arca swiss compatible?

A: Unfortunately Slik DQ-20 Compact Quick Release Adapter Set - Large is not arca swiss compatible.

Q: 9. Does this quick release plate have a flat bottom?

A: Yes it does.

Q: 10. Does this come with the 1/4-inch screw needed to attach the adapter base to the baseplate of a shoulder rig, etc?

A: The screw shown attaches to the camera. Product assumes there is a screw on tripod / monopod that attaches to the base of the adapter.