This 2.8" long Quick Release NATO Safety Rail from CAMVATE incorporates a NATO rail into your camera rig configuration. The rail has a safety pin on either end to prevent your NATO-compatible accessories from sliding off accidentally while mounted. Included 1/4"-20 mounting screws allow you to attach the rails to your camera cage.

NATO Rail    2.8" Length    Safety Pin on Each End    1/4"-20 Mounting Screws

Related Questions and Answers

Q: 1. What is the actual length of this rail? The specs say 18mm, but that must be referring to the width, as 18mm is a standard NATO rail width.

A: Tilta NATO Rail Attachment for Sony a7S III Cages is 49mm long, 21mm wide, and 8mm high.

Q: 2. Does this have a 1/4 inch screw hole in the bottom?

A: Yes, the Kondor Blue NATO Rail to Hot Shoe Adapter for Remote Trigger Top Handles (B&H# KOKBNRHSA) has a 1/4 inch female thread in the bottom. However, the way this adapter works is that you slide the foot into a cold or hot shoe and then use the included hex wrench to tighten the top screw, thereby securing the adapter in place so that it doesn't twist or jiggle. It would be less secure if simply connected to a male 1/4 inch thread on the bottom.

Q: 3. does this work with the hp 27vx?

A: No, it does not.

Q: 4. Can this be attached to SmallRig's Black Mamba cage?

A: Yes, the Smallrig Black Mamba cages offer a NATO rail mount that the SmallRig Snap-On Quick-Lock NATO Side Handle could work with.

Q: 5. Does it work with RF 400f2.8? Thanks

A: No. System will only mount the Canon EF 400mm f/2.8L IS III USM lens.

Q: 6. Will this work with the 1DX series

A: The CAMVATE Arca-Type Quick Release L-Plate for Small/Medium DSLR Cameras is too small for the Canon 1dx.

Q: 7. Will this work with Smallrigs low profile style NATO rails?

A: THe SmallRig Snap-On Quick-Lock NATO Side Handle will work with SMallRig low profile NATO accessories.

Q: 8. What is the maximum payload of this system?

A: The CAMVATE does not supply payload weight info for the Single-Grip Shoulder Rig with Manfrotto-Type Quick Release. We would recommend using the shoulder mount with payload weights of less than 14lbs.

Q: 9. Is work with 400 f2.8 is 11

A: The Wimberley AP-601 Quick Release Replacement Foot for Canon EF 400mm f/2.8L IS III USM is incompatible with the Canon EF 400mm f/2.8L IS II USM Lens. Instead, get the Wimberley Replacement Foot for Canon 400 f/2.8 IS I & II and 600 f/4 IS I & II Lenses, BH #WIRFCAP604.

Q: 10. Is this compatible with the Sirui P-204SR P Series Monopod?

A: Yes. The Sirui Quick Release Clamp will fit the P204SR monopod.