This 3.9" long Quick Release NATO Safety Rail from CAMVATE incorporates a NATO rail into your camera rig configuration. The rail has a safety pin on either end to prevent your NATO-compatible accessories from sliding off accidentally while mounted. Included 1/4"-20 mounting screws allow you to attach the rails to your camera cage.

NATO Rail    3.9" Length    Safety Pin on Each End    1/4"-20 Mounting Screws

Related Questions and Answers

Q: 1. Will the Benro BH-00 clamp fit Peak Design's Arcaplate

A: Unfortunately, this clamp on this Benro head would not fit the Peak Design Arca Plate.

Q: 2. Which country is this made in?

A: The Benro BH00 Ballhead with Quick Release country of origin is China.

Q: 3. Which quick release plate fit for Sony 200-600mm lens ?

A: This Wimberley P30 Quick Release Plate would not work with the Sony 200-600mm lens but these will all work, https://bhpho.to/3lVjnev

Q: 4. Does this work with HP 27es monitors?

A: Hi Steven, thank you for the question. The HP 27es monitors do not have VESA mounting capabilities (drilled holes), however, there are some adapters that fit into the slot where the stand normally goes, to assist in mounting with compatible systems.

Q: 5. Can this head be attached to a video tripod or video monopod from Benro?

A: Yes, this can be attached to any tri or monopod with a 3/8 -16 sized mount.

Q: 6. This plate is compatible with the 7060H E-Image tripod head ?

A: I have to give credit to Ikan, D&H forwarded me to them. Here is the answer from them. You will have to find out when your 7060H was manufactured.You can tell by looking on the head and finding the serial number. If your heads serial number is H1508XXX or higher, then you need: Model GP1If your heads serial number is lower than H1508XXX, then the plate you need is : EH6P Hope this helps! So yes if your tripod serial number is lower than H1508xxx then this plate is compatible.

Q: 7. Can this be attached to SmallRig's Black Mamba cage?

A: Yes, the Smallrig Black Mamba cages offer a NATO rail mount that the SmallRig Snap-On Quick-Lock NATO Side Handle could work with.

Q: 8. What is the actual length of this rail? The specs say 18mm, but that must be referring to the width, as 18mm is a standard NATO rail width.

A: Tilta NATO Rail Attachment for Sony a7S III Cages is 49mm long, 21mm wide, and 8mm high.

Q: 9. Is this compatible with the Sirui P-204SR P Series Monopod?

A: Yes. The Sirui Quick Release Clamp will fit the P204SR monopod.

Q: 10. Hi,Does this Ballhead work with Oben Reducer Bushing :http://www.bhphotovideo.com/c/product/769749-REG/Oben_OB_1039_3_8_16_to_1_4_20_Reducer.html?Need to get this Ballhead to fit on this tripod, and I do think will need the bushing :http://www.bhphotovideo.com/c/product/512836-REG/Giottos_QU405B_QU_405B_U_pod_Mini.html/GIMTTQSince the tripod's male thread size is 1/4 - 20 -- where this ballhead's female thread is 3/8 - 16.Looking to put on Reticam Smartphone adapter to this ballhead!Thank you.

A: Yes, the Benro BH00 Ball Head will work with the Oben Reducer Bushing (B&H # OB1039) to mount on the Giottos QU 405B (B&H # GIMTTQ).