The gray 293 18 AWG 2-Conductor Shielded Cable from West Penn has a length of 1000'. It also does not have connectors on either end.

18 AWG | 2 Conductors    Shielded    1000' Length

Related Questions and Answers

Q: 1. What is the lens diameter range the strap will fit?

A: The velcro strap on the Manfrotto 293 Telephoto Lens Support with Quick Release can expand upto a 105mm circumference to hold the lenses steady.

Q: 2. Will this work with my Manfrotto 410 Junior Geared Head?

A: The Manfrotto 293 weighs about 1 pound if the weight of your camera, lens and 293 are less than the head's capacity it should work. I have had no problems using the mount with a Nikon 7000, 105mm. micro Nikkor and a 2x teleconverter on my Giottos VGR 9264.

Q: 3. Will this support M42 types lenses, such as the Russian Tair 3 and a SMC Takumar 200 mm f/4? I would also like to know if the bracket itself can slide up and down on the tripod for camera/ lens balancing?

A: Not sure about those specific lenses. There is no slider but the bottom plate of the supports has several points below the plate to attach it to a tripod (3x 1/4 holes and 3x 1/8 holes). There is about 5 inches (12cm) between the the most forward and rearward holes so you can play with this lenght to balance the camera.

Q: 4. Can this be used with a Wimberly Gimbal head?

A: This lens support is for a lens that lacks a tripod collar, so it would be a support system on its own.

Q: 5. will this work with a Panasonic Micro 4/3 body and their 100-300mm telephoto? I have a g7 and a Gx85 and may get a GH5 or or G95.

A: Your camera system is too small for Manfrotto 293 Telephoto Lens Support with Quick Release. The lens will reach the support bar when is fully extended. You will also need to tilt the camera and lens down in order to rest the lens on the bar. The velcro strap is also too long and will need to be wrapped twice around your lens. The minimum length of the Manfrotto 293 Telephoto Lens Support with Quick Release adjustable bar is 6''. your lens starts at 5''.

Q: 6. does this work with Nikon 80-200 f2.8 push/pull lens mounted on D7100 body?

A: well i dont know that lens but it worked fine with my canon 100-400mm push\pull lens

Q: 7. Will this fit a Sony A300 DSLR?

A: Yes, the Manfrotto 293 will fit the Sony A300.

Q: 8. Will this work with my Sony RX10iv?

A: Yes and no. The RX10 Mk IV fits onto the RC2/200PL system easily, but because the barrel of the lens is smaller in diameter than the camera is tall, when parallel to the lens support, the lens support does not bear the weight of the lens at all. Using the 234 tilt head, you -could- tilt the head/camera downwards so that the lens is supported by the platform, but from testing here at the store, the lens does not exhibit significant downward weight/torque on the camera side, so it really shouldn't be necessary.

Q: 9. Is that lens support work with Nikon p1000 also I use Benro 5-section tripod with NOO ballhead

A: That strap will not work with a P1000.

Q: 10. is it working with sigma 14mm f1.8 attached with MC-11 AT Mefoto roadtrip tripod?

A: This is a universal fitting mount with an adjustable sliding color. The Sigma 14mm should fit in if you slide the support to the back.