This robust 50' Cold Weather AC Power Extension Cord with Lighted End from Bayco Products can deliver power to where you need it most during the cold months of the season. It features a 14/3 gauge thick cord wrapped in a SJTW bright yellow jacket, and is capable of supporting loads up to 15A. It's an ideal solution for getting work done out in the shed or garage. Both the 3-prong male plug and female plug are translucent, with the female end conveniently lighting up to let you know that power is running through the cable.

1-Outlet 3-Prong Translucent Female End    3-Prong Translucent Male End    Female End Lights Up When Powered    Rated for Cold Weather Use    Bright Yellow SJTW Jacket    14/3 Gauge    Supports Loads Up to 15A

Related Questions and Answers

Q: 1. What is the actual running length of the Roland PSB-1U?

A: The Roland PSB has two sections - 36in (90cm) from power plug to the brick; and 60in (150cm) from the brick to the jack - total length of 96in. I find it gives good flexibility to move around my instrument.

Q: 2. Does the bar swivel or is it always parallel to the film plane? I want a shoe mounted bar that can be parallel and also turn 90 degrees.

A: The bar swivels by slightly loosening the top screw. I use it to get my mic closer to the subject.

Q: 3. Does it work with the R-44 recorder? There are no real specs here.

A: Yes, it does.

Q: 4. Will this work for a Roland Fantom XA Keyboard?

A: The Roland PSB-1U is the recommended AC power supply for the Roland Fantom.

Q: 5. Length? Width? Height?

A: The Godox VSM-H03 Dual Cold Shoe Extension (B&H# GOVSMH03) is approximately 0.5" in height (13mm), 4.1" wide (103mm), and 0.9" deep (bar only -- knob not considered) (22mm).

Q: 6. Will it work for Roland HD1 Electronic Drum Kit

A: Yes, the PSB-120 is a direct replacement for the original PSB-1U power supply that was included with the Roland HD-1 Electronic Drum Kit.

Q: 7. will it work on a td6v drum module?

A: I wouldnt risk it

Q: 8. Can this product be used to change/install corn cob led bulbs?

A: As long as the LEDs are covered and protected it should be fine.

Q: 9. What is the Output Voltage and Amperes?AND is it compatible with original-older Zoom H4n?Thank you!

A: I have been using this to power my older Zoom H4n and it works great!

Q: 10. Will this work with Roland Cube Street amp?

A: Yes, the Roland Cube Street ships with a PSB-1U adapter. The original PSB-1U , or this newer PSB-120 adapter would power it safely.