Designed to test HDMI and Mini HDMI cables with ease, this Jonard Tools HDMI Cable Tester is the perfect tool for evaluating HDMI cables that may have shorts, open circuits, or have wire pairs in the wrong order.

From HDMI 1.2 to 2.0 Cables    For HDMI or Mini HDMI Cables    Detachable Remote    Tested on Cables up to 1640'

• Perfect for use on 1.2, 1.3, 1.4, and 2.0V HDMI or Mini HDMI cables
• Scan mode allows you to see each individual connection being tested
• Full Display mode shows all of the tested connections at once
• Remote can be detached from the main unit, allowing you to quickly and easily test HDMI cables that are installed or very long
• Auto-shutdown function after 10 minutes helps preserve battery life
• Works on any cable length (tested up to 1640')
• Includes 9V battery required for operation

Related Questions and Answers

Q: 1. I am new to this and see that there might be a difference between BNC connectors. Will this test a BNC plug RG58 Coax Coaxial Cable Kable 50ohm RF?

A: Yes, the Whirlwind MCT7 Multi Connector Cable Tester is capable of testing both 50 and 75 ohm BNC coaxial cables.

Q: 2. Can this be used as BOTH a source and display emulator at the same time to test a cable? It says it can be a sig gen OR display

A: According to the manual, there is no mention of dual operation being impossible at the same time when using the Vanco Handheld 4K HDMI Tester.

Q: 3. Can each of these elastic loops hold a Canon LP-E19 battery, or are they too tight for such a large battery?

A: The Tenba Tools Cable Pouch (Black) loops are too small for the anon LP-E19 Battery Pack.

Q: 4. Does the tone generator create a 1Khz tone for audio unity sweep purposes?

A: Yes, as per Kopul; the test tone is -50dB/-10dB/+0dB at 1khz.

Q: 5. is there a way to test USB3 reliably or if not is there a model w usb3?

A: This cable tester can be used for USB 3 cables which are type-A to type-B. It will only test the cables ability to send signal from A-B, not data rates or speeds.

Q: 6. How does this indicate when two pins on a connector are shorted? How indicate when cable is wired to wrong pin on connector? Thanks

A: It would show, according to the LED lights, which wire is connected to which pin.

Q: 7. Can I test SDI Video Cable?

A: The CBT-12 does not have BNC jacks for testing SDI video cable, so you would have to use the two removable leads included for testing wire or cable with jacks that are not included.

Q: 8. Does the tone generator send the tones on all of the connectors, including the RJ45? Can one use an inductive probe to trace wires with the generated tones?

A: Yes it sends a tone on RJ45. The tone is only to signal 1st line as it cycles through the 8 lines of ethernet cable. The additional continuity is tested using the 8 led's

Q: 9. Does it test sdi cables?

A: Yes. SDI is just standard BNC cables, which this cable tester can check.

Q: 10. Hi Guys, the TC-NT2 you have pictured is the discontinued Version 1.0 . Trendnet have updated this to Version v1.1R , is this the one you are shipping?

A: Hi Guys, it looks like you have updated the picture to the Version v1.1R now.