You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Phones: 800
$ USD
  • Your shopping cart is empty!

Jbl Control 12c/t Professional Series 3" 40w Passive Ceiling Loudspeaker (pair, White)

Jbl Control 12c/t Professional Series 3" 40w Passive Ceiling Loudspeaker (pair, White)
  • Product Code: ga11875
  • Availability: In Stock

$510.00 $714.00

The white JBL Control 12C/T is a pair of Professional Series 3" 40W passive ceiling loudspeakers designed to deliver generous coverage and pleasing sound for low- to medium-volume applications such as offices, retail stores, hotels, and educational institutions.

Featuring a 3" full-range driver that handles up to 40W of continuous program power, the Control 12C/T is capable of producing a peak maximum SPL of 103 dB and a frequency range of 68 Hz to 17 kHz (-10 dB) while its 130° conical dispersion pattern ensures more coverage with fewer speakers.

The integrated 15W multi-tap transformer offers taps at 70V and 100V, plus a transformer bypass setting for low-impedance operation at 8 ohms. The UV-resistant, paintable ABS baffle comes with a pre-attached back can that enables fast and simple installation.

1 x 3" Full-Range Driver    40W Continuous Power Handling    130° Conical Coverage Pattern    Integrated Multi-Tap Transformer    Supports 70V, 100V, or 8-Ohm Operation    103 dB Peak Maximum SPL    Removable Locking Input/Thru Connector    Blind-Mount Back Can for Easy Install    Dual Conduit/Cable Clamps

Key Specs
Active/PassivePassive
Number of Included Speakers2
Speaker ConfigurationFull-Range
Power HandlingAt Low-Z:
40 W Program
Constant Voltage / Transformer Taps70 V:
15 / 7.5 / 3.8 / 1.9 W or 8 Ohms Bypass
100 V:
15 / 7.5 / 3.8 W or 8 Ohms Bypass
Impedance8 Ohms (Nominal)
Full-Range Driver1x 3" / 7.62 cm Cone
Frequency Range68 Hz to 17 kHz -10 dB
ColorWhite
Speaker
Active/PassivePassive
Number of Included Speakers2
Speaker ConfigurationFull-Range
Power HandlingAt Low-Z:
40 W Program
Constant Voltage / Transformer Taps70 V:
15 / 7.5 / 3.8 / 1.9 W or 8 Ohms Bypass
100 V:
15 / 7.5 / 3.8 W or 8 Ohms Bypass
Impedance8 Ohms (Nominal)
Transformer Wattage15 W
Enclosure TypeBass-Reflex
ShieldedNo
Drivers
Full-Range Driver1x 3" / 7.62 cm Cone
Performance
Frequency Range68 Hz to 17 kHz -10 dB
Frequency Response95 Hz to 15 kHz ±3 dB
Maximum SPL97 dB (Continuous)
103 dB (Peak)
Sensitivity84 dB (Half-Space)
Coverage Angle130° (Conical)
Directivity7.4 dB (Directivity Index)
9.8 (Directivity/Q Factor)
Connectivity
Inputs/Outputs1x Screw Terminal 4-Pin Speaker Input/Thru (Locking, Removable)
Maximum Wire Gauge12 AWG / 2.5 mm
Physical
CertificationsUL
Environmental ResistanceNo
ColorWhite
MountingIn-Ceiling
Cutout Size6.7 x 6.7" / 17 x 17 cm
Mount Surface ThicknessUp to 1.4" / 3.6 cm
Construction MaterialABS, Steel
Dimensions7.7 x 5.4" / 19.56 x 13.72 cm
Weight3.5 lb / 1.6 kg (Each Speaker)
Packaging Info
Package Weight15.5 lb
Box Dimensions (LxWxH)26.5 x 9.9 x 9.8"

For low- to medium-volume applications such as music cafes, business music systems, retail stores, music/paging systems, airports, reception/waiting rooms, lounges, courtrooms, convention centers, hotels, and educational facilities

3" full-range driver with a lightweight high-temperature Kapton voice coil former and an aluminum coupling ring to reduce distortion and extend the high-frequency response of the system

FEA-optimized motor construction and cone geometry allow for smooth frequency response and improved off-axis performance

Butyl rubber surround provides long-term durability and good sonic damping, and the polypropylene cone is resistant to water and humidity

Blind-mount back can for quick and easy installation

Vented, paintable baffle made of UV-resistant UL94-V0 material

Integrated multi-tap transformer allows 70V, 100V, or 8-ohm operation

68 Hz to 17 kHz bandwidth (-10 dB) with wide 130° coverage

Removable locking connector with screw terminals for secure wire termination and "loop through" terminals

Dual strain relief assembly provides clamping for use with cable or flex conduit

Related Questions and Answers

Q: 1. Recomended 8Ω JBL or CROWN amplifier for 2 per channel 18C/T?

A: The JBL CSA 2120Z Audio Amplifier - 2 x 120W (B&H # JBCSA2120Z) that James recommended is a good option since it can be used as a 70V or standard amp and its power rating makes it a good match for use with two of the JBL 18C/T speakers on each channel. Crown's XTi 1002 (B&H # CRXTI1002) is a standard stereo amp rated at 275W per channel at 8 Ohms which could also work for you. As another option, the QSC ISA300Ti Commercial Power Amplifier (B&H # QSISA300TI) is a standard amp rated at 180W per channel at 8 Ohms and also operates at 70V for a constant voltage setup.

Q: 2. Can you use them outdoor ?

A: These speakers are not outdoor rated.

Q: 3. I'm looking at using these for a church system. what do you recommend the placement to be between each speaker on a 9'-12' cathedral ceiling? Do you connect to both 2,3 and 1,4 to daisy chain the speakers or just 1,4 for the loop thru to the next speaker? And finally, can you use a standard 1/4 mono plug to speaker wire to connect the speakers?

A: Unfortunately for such a large job, we would not be able to make accurate recommendations or product suggestions off site. We would highly recommend bringing in a project professional who could inspect your location and make the appropriate recommendations per your design criteria. While we cannot make a specific recommendation, one of our manufacturers does offer this type of service. TOA Electronics is a premier manufacturer of audio and security products and does offer onsite design and installation. B&H would be more than happy to bid out the products required for your project.Please contact Johnathan Allen at 845-729-3482 / jonathan_allen@a href= http://toaelectronics.com. target= _blank toaelectronics.com./a He is an install professional that will be able to handle this type of large project for you.

Q: 4. What ceiling mounting accessories are recommended for this product?

A: According to Page 03 & 04 in the Installation Manual for the JBL CONTROL 18C/T, it comes with a C-Bracket that is compatible with most ceiling material. A tile rail can be used with tiled ceilings. There is also the JBL MTC-47MR Mud-Ring Bracket, available separately as BH #JBMTC47MR that can be used in the plaster for new ceiling constructions. You can find the manual from the 'Downloads' tab on the JBL product page for the CONTRL 18C/T, linked here: https://jblpro.com/en-US/products/control-18c-t

Q: 5. Can these be used for outdoor applications?

A: not really, unless you have weather proof casing for them

Q: 6. Can you use these speakers on a regular home amplifier?

A: The JBL Control 26CT are designed to be use with a 70v commercial amplifier. A home receiver lacks the necessary transformer found in commercial amps like the JBL CSA 1120Z Audio Amplifier; B&H# JBCSA1120Z.

Q: 7. Are these speakers appropriate for a receiver, Muti-CD player and turntable in a family room setting? Is the amplification good for this?

A: Yes the JBL Control 1 Pro is ideal for this kind of application.

Q: 8. Is this price for a pair or single? JBL ships in pairs

A: The JBL Control 45C/T is sold individually. This item includes a single speaker with mounting hardware.

Q: 9. Do these have anyway to be mounted on a stand? Such as a microphone stand that some of the other compact loudspeakers do? I won't be able to wall-mount these, need them portable.

A: They shop with the available wall mount hardware. They can also sit on a desk/tabletop. They don't have holes on the bottom to be mounted on a mic stand. Behringer makes a similar item that has stand mount holes in the bottom, but are self powered.

Q: 10. Does this product come with a pendant mount kit?

A: The Bose Professional FreeSpace FS4CE In-Ceiling 4.5" 200W Passive Loudspeaker (Pair, White) comes with mounting hardware for in-ceiling installation, as this is an in-ceiling speaker, not a pendant speaker.

17/09/2024

First pair were defective, but B&H immediatly took care of that. Second pair are so on the money and produce a brilliant and unexpected sound. They are being driven by an Onkyo A-5VL amp. Perfect setup for small homes, apartments and offices where you can get away with some occasional loudness :-)

5

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Top Bestselling Products

Muxlab 40w Dante In-ceiling Poe Speaker

$1,886.85 $2,924.62

Muxlab Passive 40w Coaxial Ceiling Speaker

$596.85 $716.22

Jbl Go 4 Portable Bluetooth Speaker (camo)

$149.85 $236.76

Jbl Go 4 Portable Bluetooth Speaker (red)

$149.85 $197.80

Jbl Boombox 3 Portable Bluetooth Speaker (squad)

$1,499.85 $1,949.81

Jbl Bags Jbl-sub-18t Rolling Sub Transport Case

$1,229.97 $1,808.06

Jbl Bags Transporter For Prx One Speaker

$445.20 $609.92

Epos Expand 80t Usb-c And Bluetooth Speakerphone

$2,157.00 $3,408.06

Products You May Like

Dji Nd Filter Set For Air 3 (4-pack)

$269.52 $404.28

Tiffen 62mm Black Diffusion/fx 1/2 Filter

$239.97 $338.36

Hive Lighting Profoto To Bowens Adapter

$299.97 $395.96

E F Note Floor Tom (13", Black Oak)

$1,437.00 $2,256.09

Tiffen 58mm 82a Light Balancing Filter

$105.00 $148.05