When you're on a busy set and need to change settings for a Bolt 6 LT wireless setup for your monitors, it may get confusing which one is which when there are so many wireless setups. Teradek has devised a clever way of identifying your synced transmitter and receiver set with this red Color Band to wrap around your receiver to match its partner on the other end. This flexible red silicone band wraps around the Bolt 6 LT receiver and allows you to see the color of the unit and find its paired device.

ID Synced RX/TX Pairs on a Busy Set    Designed for Sets with Many Monitors    Fits Around Bolt 6 LT RX    Flexible Silicone Band    Comes in Red Color

Related Questions and Answers

Q: 1. How can I take antenna off?

A: The antennas on this unit are standard antennas they screw into the unit and can be taken off the same way, this unit does not come with the the antennas attached

Q: 2. Does Bolt 6 HDMI pass start/stop flags of Canon R6 or Red Komodo? (I have tried but I can't get it to work)

A: The Teradek Bolt 6 LT HDMI 750 Transmitter/Receiver Kit is not listed as being able to start/stop camera recording.

Q: 3. Can someone at B&H test to see if this works with the Sony A7s iii? A review said that there is an issue.

A: Yes, the Teradek Bolt 6 LT 750 3G-SDI/HDMI will work with the Sony A7SIII.

Q: 4. What’s comes with the deluxe package ?

A: In the box of the Teradek Bolt 6 LT 750 3G-SDI/HDMI Wireless RX/TX with Case Deluxe Kit (Gold Mount), you will find the following: Teradek Bolt 6 LT 750 3G-SDI/HDMI Wireless RX/TX with Case Deluxe Kit (Gold Mount) Bolt 6 LT 750 3G-SDI/HDMI Transmitter Bolt 6 LT 750 3G-SDI/HDMI Receiver (Gold Mount) 2-Pin to D-Tap Power Cable (18") USB-A 2.0 Male to Micro-USB Male Cable (39") 2 x HDMI Type A Male to HDMI Type A Male Cable (18") 2 x BNC to BNC SDI Cable (10") 2-Pin to 2-Pin Connector for ALEXA (18") AC Adapter with Cable (6') 7 x Antenna 1/4"-20 Light Stand Adapter Shoe Adapter 2 x Screw Wooden Camera Offset Mount Carry Case Limited 1-Year Manufacturer Warranty

Q: 5. Does the kit come with a hard case? Thanks.

A: Yes, the Teradek Bolt 6 LT HDMI 750 transmitter/receiver it comes in a hard case.

Q: 6. Can I use more than one tx / rx pair in the same environment?

A: It should theoretically be possible to use 6 Teradek Bolt 6 LT HDMI 750 Transmitter/Receiver Kits in a single location if you are all using fixed frequencies and there is minimal external interference in the area. The spacing of the equipment will also be incredibly important. With the Bolt 6 you'll want to have at least 10 feet between the transmitter and the receiver, and between other sets. If more receivers are used in a set this will impact the communication even more so. The Bolts operate in the unlicensed 5 GHz spectrum which can be use by other devices like WiFi routers, other wireless transmitting systems, etc. Here is an article that may be helpful: https://support.cs.inc/s/article/Bolt-4k-Best-Practices-for-Interference

Q: 7. Can you use HDMI out and SDI in (or the opposite) at the same time?

A: When using the Teradek Bolt 6 LT 750 3G-SDI/HDMI Wireless RX/TX Deluxe Kit (V-Mount) the only output for HDMI is on the receiver. Although the Teradek Bolt 6 LT 750 3G-SDI/HDMI Wireless RX/TX Deluxe Kit (V-Mount) has bidirectional signal, it is limited.

Q: 8. can you transmit too 3 receivers?

A: The Teradek Bolt 6 LT HDMI 750 Transmitter/Receiver Kit is a 1 to 1 system only.

Q: 9. Is there a PTap port on the Anton Bauer plate to power other accessories?

A: Please note that the Teradek Bolt 6 LT HDMI 750 Wireless Receiver BH #TE102267 does not come with a V-Mount plate. The following Teradek Blot 6 comes with a V-Mount battery plate and one DTap connector on the plate. Teradek Bolt 6 LT HDMI Wireless Receiver (V-Mount) BH #TE102267V

Q: 10. Does this receiver come with both plates, male and female?

A: The Teradek Bolt 6 LT HDMI Wireless Receiver (V-Mount) comes with a female V-Mount Battery Plate.