Designed to support FotodioX and other brand reflectors measuring 22 to 60" in width, the aluminum 60" Reflector Arm with Universal Grip mounts on a stand using a grip head that allows the shooter to slide the telescoping arm backward or forward to accommodate the size and weight of the reflector, which attaches via two clips.

Clips to Hold 22 to 60" Reflectors    Rotating Joint, Tilt & Angle Adjustments    Universal Grip Fits Most Light Stands    Grip Head Holds Arm

Related Questions and Answers

Q: 1. are there any barn doors that could fit onto these reflectors?

A: Unfortunately, the manufacturer does not offer a set of barndoors to fit the 26° and 60° Reflector Kit for the Evoke 1200.

Q: 2. Will this grip arm support work with other C-stands with grip arms, i.e. A Matthews Hollywood C-Stand?

A: It can work with any C-stand but you will also need a Kupo 3 way clamp, this fits the C-stand. The grip arm can't be greater than 16mm (I had to look that up on the Kupo site). I bought this when I tried to mount a Westcott Apollo Orb, and pair of Cactus RF60 Flashes with battery packs and it was able to keep it in position. Without it I couldn't keep it upright.

Q: 3. Will this be compatible with the Profoto B10 products?

A: Yes

Q: 4. Will this reflector work on the Profoto B10?

A: Yes it will

Q: 5. Will this hold a Profoto 33" collapsible reflector??

A: Yes, the Avenger RH353 Reflector Holder with Mini Grip Head, B&H # AVRH353, listed above will hold the Profoto Collapsible Reflector 33".

Q: 6. Does this reflector accept standard 7" honey comb grids?

A: You should be able to use a 7" grid of choice.

Q: 7. Can I use this production Profoto D1 or B1x ?

A: As the FotodioX Pro PopSpot Ultra 7" Reflector, B&H # FOPSREFLECT7, is designed for use on Profoto light fixtures and uses the standard Profoto speedring connection, yes, it would be compatible for use with both the Profoto D1 Air Monolight and the Profoto B1X AirTTL Monolight.

Q: 8. Is this similar to the Manfrotto one, are they the same?

A: Thank you everyone.

Q: 9. Hi!! Will this fit in Manfrotto 5002BL Nano Plus Stand (6.5')?

A: yes. just would suggest a sandbag to weigh down the unit so it stays in place.

Q: 10. Can I use the Avenger RH353 Reflector Holder with a Manfrotto 5001B?

A: I use my RH353 with a Manfrotto 5001BAC...had some difficulty attaching the clamp to the top section of the light stand, as the diameter of the light stand pole seemed a bit too large for the RH353's clamp. Ultimately got it to work, though. Used indoors only with a 40 collapsible reflector attached with the holder at approx. 90 degrees to the light stand, and the whole rig was very stable. BobH