When you're on a busy set and need to change settings for a Bolt 6 XT wireless setup for your monitors, it may get confusing which one is which when there are so many wireless setups. Teradek has devised a clever way of identifying your synced transmitter and receiver set with this red Color Band to wrap around your transmitter to match its partner on the other end. This flexible red silicone band wraps around the Bolt 6 XT transmitter and allows you to see the color of the unit and find its paired device.

ID Synced RX/TX Pairs on a Busy Set    Designed for Sets with Many Monitors    Fits Around Bolt 6 XT TX    Flexible Silicone Band    Comes in Red Color

Related Questions and Answers

Q: 1. Will this work on a Teradek Ace 800 TX ?

A: Yes, The Teradek Wireless Antenna for Bolt 500/1000 Tx & Rx, Bolt 3000 Rx 2db antennas will work.

Q: 2. Do I have to power the SmallHD 702 Monitor and Trade Transmitter Separately or does it pass through power?

A: The Teradek Bolt 6 Monitor Module would share power and video with the connected display, allowing you to reduce cables required on set.

Q: 3. Does this work for Teradek Bolt 4k 1500 Tx & Rx? And if not, where can I find replacements?

A: The Bolt 4K 1500 is not listed in the compatible models, which are: Bolt 500/1000 Tx & Rx, Bolt 3000 Rx.

Q: 4. Is this compatible with the teredek bolt 6 units?

A: Yes, the Hawk-Woods TX Teradek Bolt Holder V-Lok could also work with Teradek Bolt 6 TX units as well.

Q: 5. So two different answers on the compatibility with the bolt XT. Can somebody confirm if this can work on it or not? One of the answers left a link to a discontinued item

A: This is compatible with the Bolt 500 XT. According to Teradek part number 11-0022 is the correct antenna.

Q: 6. Does this work for the Teradek Video Go?

A: Yes, This Antenna could be used with the Teradek Vidiu Go.

Q: 7. Will this work with Paralinx Triton Model TR888T?

A: This is tested and compatible with the Bolt 500/1000 Tx & Rx, Bolt 3000 Rx.

Q: 8. Will this system support two receivers to one transmitter?

A: Yes, When using the Teradek Bolt 6 XT 750 you can transmit to up to six Bolt 4K or Bolt 6 series receivers. It is only one Transmitter (input) to up to six Receivers (Output).

Q: 9. Are those Arri standard pins on the non-teradek side?

A: Yes, the Wooden Camera Mounting Bracket for Teradek Bolt 4K LT TX provides an ARRI style 3/8"-16 thread with locating pin depressions.

Q: 10. So SDI to HDMI out to HDMI in, that must add some latency. How much?

A: The latency during conversion is low, by about 1ms on Teradek Bolt 6 Monitor Module 750 TX for Smart 7 Series Monitors.