When you're on a busy set and need to change settings for a Bolt 6 XT wireless setup for your monitors, it may get confusing which one is which when there are so many wireless setups. Teradek has devised a clever way of identifying your synced transmitter and receiver set with this yellow Color Band to wrap around your transmitter to match its partner on the other end. This flexible yellow silicone band wraps around the Bolt 6 XT transmitter and allows you to see the color of the unit and find its paired device.

ID Synced RX/TX Pairs on a Busy Set    Designed for Sets with Many Monitors    Fits Around Bolt 6 XT TX    Flexible Silicone Band    Comes in Yellow Color

Related Questions and Answers

Q: 1. So SDI to HDMI out to HDMI in, that must add some latency. How much?

A: The latency during conversion is low, by about 1ms on Teradek Bolt 6 Monitor Module 750 TX for Smart 7 Series Monitors.

Q: 2. Will this work with Paralinx Triton Model TR888T?

A: This is tested and compatible with the Bolt 500/1000 Tx & Rx, Bolt 3000 Rx.

Q: 3. Does this work with the 703?

A: The Teradek Bolt 6 Monitor Module 750 TX for Smart 7 Series Monitors is incompatible with the SmallHD 703 UltraBright On-Camera Monitor. The transmitter can connect to SmallHD’s Cine 7, 702 Touch, and Indie 7 Smart Monitors.

Q: 4. Will this fit the updated Bolt 6 LT TX? I have the HDMI version

A: The dimensions on paper would appear to work for housing the newer Teradek Bolt 6 LT series TX. We will not be able to test this unfortunately.

Q: 5. is this a male or female connector?

A: This is a female connector.

Q: 6. Does this work for the Bolt 500 XT Transmitters? What’s the difference between this and the one for $30?

A: Yes, according to Teradek this is compatible with the Bolt 500XT Transmitter.

Q: 7. Hello, will this fit the new Teradek 6 LT series either the 1500 & 750 receivers?

A: No, the Teradek Bolt 1000 LT and 500 XT RX Battery Plate will not support the Teradek 6 LT. Please work with the plates listed below. The plates below will work with the 1500, and 750 Transmitter, or Receiver. Female Battery side V-mount: Teradek Single-Battery Plate for Bolt (Female, V-Mount) BH #TE110854 Male Camera side: Teradek V-Mount Battery Plate for Bolt 4K Monitor Module (Male, Camera Side) BH #TE110855

Q: 8. this works with teradeck 750?

A: Yes, this will work with the Teradek 750.

Q: 9. So two different answers on the compatibility with the bolt XT. Can somebody confirm if this can work on it or not? One of the answers left a link to a discontinued item

A: This is compatible with the Bolt 500 XT. According to Teradek part number 11-0022 is the correct antenna.

Q: 10. Is this compatible with the teredek bolt 6 units?

A: Yes, the Hawk-Woods TX Teradek Bolt Holder V-Lok could also work with Teradek Bolt 6 TX units as well.