Designed for 550 MHz high-speed data applications, such as 100BASE -TX, 100BASE-VG, and 155 ATM, as well as high-speed applications, such as 622 ATM, Wideband, Ethernet 1000BASE-T, and emerging applications with anticipated data rates to 3.2 Gb/s, the yellow Cat6 550 MHz Shielded Stranded LAN Cable from Comprehensive comes in 1000' lengths marked off in one foot increments; so you can make cables of any length as needed. It is packaged in a simple pull-through designed box to keep this bulk cable free of kinks and knots. It follows the Cat6 standard and has been constructed using four shield twisted pairs wrapped in a sturdy PVC (polyvinyl chloride) jacket that perform well in noisy environments, feature strong attenuation and crosstalk characteristics, as well as 24 AWG stranded bare copper conductors.

Cat6 Standard    1000' Length    Four Pairs of Shielded Twisted Wire    550 MHz Transmission Speed    Designed for Fast & Gigabit Ethernet    24 AWG Stranded Bare Copper Conductors

High-performance data communications cable for noisy environments

Suitable for 550 MHz high-speed data applications, Gigabit Ethernet, fast Ethernet, and 155 Mbps TP-PMD/CDDI

Cat6 Shielded Twisted Pair (FTP) cable

Four easily identifiable color-striped twisted pairs

24 AWG stranded bare copper conductors

Good attenuation and crosstalk characteristics

Exceeds EIA/TIA 568 B.2-1, UL, CSA, and ISO/IEC 11801 specifications

UL/cUL or ETL listed

Sequential foot markers

Related Questions and Answers

Q: 1. Does it carry Phantom Power? No mention of shielding either.

A: This will carry phantom power. Here are more technical specs: • Inner conductor: 4 x 2 conductors / Bare Copper 7 x 0.20 mm (22 AWG) • Number of conductors: 8 • Inner conductor section: 0.22 mm² • Isolation: HDPE 0.95 mm • Conductor twisting: Yes • Outer jacket: PVC • Outer jacket color: Black • Outer jacket diameter: Ø 6.5 mm

Q: 2. Is this a shielded cable? Would it be suitable for AES500 connections?

A: Yes it is shielded and If the units being connected run over Cat6 Ethercon, than this should work.

Q: 3. If used with a the EW-DX EM 4, could use the antennas from the EM 4 by using the RF out of the EM 4 to the RF in on the EM 2?

A: Yes, the RF in of the Sennheiser EW-DX EM 2 DANTE Two-Channel Digital Rackmount Receiver can be connected to the RF out (A and B) of the Sennheiser EW-DX EM 4 DANTE Four-Channel Digital Rackmount Receiver to utilize the 2 x 1/4-Wave Rod Antenna.

Q: 4. Is this pure copper or copper-clad aluminum wire (CCA) cable?

A: This cable uses copper-clad aluminum wire (CCA).

Q: 5. Looking for cheaper alternatives to Tether Tools cables. Does this cable allows to make tethered capture with lightroom and sony A7 III ?

A: Any USB cable can be used for tethering, but the Tethertools are made specifically for tethering. Your results may vary for dropped files.

Q: 6. Is this cable easy to lay out rewrap and layout again? Is it as flexible as say a 100" XLR Mic cable?

A: I would say it would be slightly more ridged, but it still would be capable of easily being re rapped.

Q: 7. Does it work with 220v AC power?

A: The unit will accept multi-voltage.

Q: 8. Is this cable shielded?

A: The American DJ CAT6 Pro Series EtherCON Cable (50'), would be a shielded cable.

Q: 9. Does this work with a Displayport (Version 1.2) monitor and workstation?

A: Yes

Q: 10. Is this panel PoE compliant?

A: The Platinum Tools 24-Port Cat6 Shielded Patch Panel (1 RU) does indicate POE compliance.