You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Phones: 800
$ USD
  • Your shopping cart is empty!

Schoeps Colette Cmc 1 U Microphone Amplifiers And Mk 41v Supercardioid Capsules Stereo Set (matte Gray)

Schoeps Colette Cmc 1 U Microphone Amplifiers And Mk 41v Supercardioid Capsules Stereo Set (matte Gray)
  • Product Code: ga125246
  • Availability: In Stock

$10,320.00 $13,003.20

The matte gray Schoeps CMC 1 U is a miniature Colette Series microphone amplifier offering uncompromising high fidelity in a lightweight and ultracompact form factor for studio recording, broadcast, and live stage applications. Presented as an alternative to the renowned Schoeps CMC 6 amplifier, the CMC 1 U is compatible with all existing MK mic capsules and Colette active accessories (all available separately).

It features a balanced XLR output, compliance with 12 or 48V phantom power, and low current consumption. Its Schoeps RFI Shield provides high immunity from RF interference for a clean, low-noise signal. The CMC 1 U supports the high maximum SPLs tolerated by the various MK mic capsules (available separately).

Spot Microphones in Orchestra, Speech    2 x CMC 1 U Miniature Mic Amplifiers    2 x MK 41V Supercardioid Matched Mics    2 x SG 20 Stand Mounts with Swivels    2 x B 5 Solid Foam Popscreens    Premium Case    Lighter, Smaller Option to CMC 6 Amp    XLR Output    Operates on 48 or 12V Phantom Power    RFI Shield Protects from RF Interference

Parameters
Frequency Range20 Hz to 20 kHz
Maximum Output Voltage1.8 V / 5 dBV with 1-Kilohm Load
Maximum SPL for 0.5% THDP48 with MK 4 Capsule: 135 dB SPL
P12 with MK 4 Capsule: 131 dB SPL
Impedance50 Ohms (±1 Ohm, 8 Hz to 50 kHz)
Minimum Load Impedance1 Kilohm
SensitivityCapsule-Dependent Sensitivity
Low-Cut Filter12 dB/Octave at 20 Hz
Common Mode Rejection Ratio>55 dB at 1 kHz
Maximum Cable LengthUp to 1312' / 400 m
Output Connector1 x 3-Pin XLR Male
Operating Current ConsumptionP48: 2 mA
P12: 3 mA
Operating VoltageP48: 30 to 52 VDC
P12: 11 to 13 VDC
Length1.4" / 36 mm
Diameter0.8" / 20 mm
Weight1.3 oz / 36 g
Packaging Info
Package Weight0.72 lb
Box Dimensions (LxWxH)7.4 x 4.3 x 1.3"

  • Complete alternative to the renowned CMC 6 amplifier
  • Can be used in place of the CMC 6 with no compromise
  • XLR output connector
  • Electrical characteristics of the CMC 1 U are equal to, or even better than, those of the CMC 6
  • 1.4" long (about a third the size of the CMC 6)
  • 1.3 ounces (about 40% lighter than the CMC 6)
  • Fully compatible with all existing MK capsules and Colette active accessories such as the CUT 60 and RC tubes
  • Very high immunity from RF interference with the Schoeps RFI Shield
  • Includes mic clip for easy attachment to a mic stand
  • Suspension mounts such as the Rycote INV-6 are available separately

Related Questions and Answers

Q: 1. Will this suspension fit with Sennheiser 8040, 30 and 40?

A: It might but it comes with all the Schoeps mic's. You cannot buy this without the mic's.

Q: 2. Would the MKH 8050 make a good on-camera mic? on the Blackmagic 6K Pro?

A: The Sennheiser MKH 8050 Compact Supercardioid Condenser Microphone is not really designed as an on-camera mic, but it could be used in that manner if needed.

Q: 3. Will this work for the DPA 4018c? Seems like it would due to the size of comparable mics.

A: Yes, the Rycote 041110 InVision INV-6 SOFT Shockmount is compatible for use with the DPA Microphones 4018C Compact Supercardioid Microphone,

Q: 4. Considering this stereo set and the single version. What I need it for is capturing audio from multiple speakers when I don't have enough inputs into my camera. Is the stereo version really necessary?

A: If you are okay recording in mono than just get one mic. If you want to record in stereo you will need the stereo set.

Q: 5. Would you use these mics on a camera for field reference audio?

A: Yes, the Rode NT55 Compact Condenser Microphone with Interchangeable Capsules could be used on a camera with XLR inputs providing phantom power to capture reference audio. The cardioid capsule included with the NT55 is suggested as opposed to the omni capsule for this application, in order to capture an audio perspective reflective of what the camera is seeing.

Q: 6. What is the best windshield (dead cat) that will fit?

A: Since the Sennheiser MKH 8050 Microphone is only 2.9" long with a 19mm diameter, you can use the Bubblebee Industries "The Spacer" Bubble Windshield & Fur Cover System for Small-Diaphragm Mics - Black, Extra-Small (B&H # BUBBISBXS) or the Rycote Baseball Felt-Covered Windscreen - Black, 19/20mm, Single (B&H # RY039701). Both items will fit properly and will provide sufficient protection from wind noise. If you need a replacement for the foam windscreen that comes included with the mic, you can order the Sennheiser MZW-8000 Windscreen for MKH8000 Series Microphones (B&H # SEMZW8000).

Q: 7. I have one 8020, if I want to get a pair, is it better to buy a pair or buy another one, i guess my question is, does the single version makes any difference with the pair version?

A: In terms of matching capsules, it is more ideal to purchase the Sennheiser MKH 8020 Compact Omnidirectional Condenser Microphone as a set, however purchasing two individual microphones will still provide great results when used as a pair.

Q: 8. is there a recommended pistol grip for shooting situations where a boompole is not feasible? for the mkh50

A: The Auray Universal Microphone Pistol Grip (BH #AUGRIP) is a recommended handheld pistol grip for adapting to the shock mount and microphone in the Sennheiser MKH 50 Supercardioid Microphone Kit.

Q: 9. The question isn't why are 2 mics more expensive than 1, it is why is there a $100 premium over buying 2 separately. Is it because they are 'matched'?

A: The difference in cost between purchasing two Rode NT55 Compact Condenser Microphones with Interchangeable Capsules as opposed to the Matched Pair item can indeed be credited to the fact that the pair is matched, making them more ideal for recording as a stereo pair.

Q: 10. Where is the MKH 50 made?

A: Country Of Origin GERMANY

There are no reviews for this product.

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Top Bestselling Products

Arri B-mount For Bms-2 (set Of 2)

$2,130.00 $3,408.00

Tiffen 2 X 2" Black Pro-mist 1/8 Filter

$463.50 $662.80

Fix It Sticks Hook-and-loop Patch

$18.00 $25.92

Arri Artemis 2 Volt Shorty Post Basic Set

$53,670.00 $69,234.30

Gvm B100c Foldable Rgb Led Light Panel

$1,197.00 $1,651.86

Arri Gold Mount Set For Bms-1/bms-2

$2,130.00 $2,747.70

Products You May Like

Gvm Softbox For Yu200r Led Light Panel

$324.00 $430.92

Bower Nikon P6000 Adapter Tube 52mm

$53.13 $75.98

Godox Gobo Set 1

$26.97 $38.84

Portabrace Cs-b9 Stuff Sack

$42.87 $54.02

Falcam Full Motion Swivel Arm

$269.70 $356.00

K&m 24481 Speaker Wall Mount (white)

$341.97 $516.37

Heliopan Bay 1 Rg 610 Infrared Filter

$350.85 $505.22