The Hasselblad XPan Lens Adapter allows you to use XPan lenses with the X1D Camera. Although the XPan lenses have been discontinued they were available in the following focal lengths: 30mm f/5.6, 45mm f/4, and 90mm f/4. The slim line adapter only adds 21.4mm to the length of the lenses and weighs just 4 oz to maintain the lightweight design philosophy of the X1D camera system.

Adapts XPan Lenses to X1D Camera

Related Questions and Answers

Q: 1. does this adapter allow for autofocus?

A: While the Hasselblad XH Lens Adapter maintains electronic communication, it does not support autofocus yet.

Q: 2. Is there a crop factor on this adapter?

A: There is no crop factor

Q: 3. Does this adapter allow infinity focus on Nikon Z bodies?

A: Yes. Please note that after mounting the adapter while infinity focus is available only manual mode will be accessible in shooting mode.

Q: 4. Will the XV lens adapter be able to trigger the leaf shutter inside Hasselblad V lens? Or will it use the electronic shutter on X2D

A: The Hasselblad XV Lens Adapter only works with the camera's electronic shutter. Unfortunately the leaf shutter cannot be used.

Q: 5. What's the lens crop factor ?Any lens vignette ?Is there a lens lock switch to prevent lens falling out of the adapter ?

A: A Hasselblad V mount camera has a film size of 60mm x 60mm. A Hasselblad X mount camera has a sensor of 44 x 33 mm so yes, cropping indeed. Vignetting would depend on the lens. But since there is cropping, most likely there will be no vignetting. Yes, there is a locking pin. And being Novoflex, there is no flex because their products are unsurpassed in quality.

Q: 6. Will this adapter work on The Hasselblad 907x camera?

A: It should mount without issue as the 907X uses the same Hasselblad X-mount.

Q: 7. Does this adapter change the effective focal length of the V lenses, ie. is an 80 mm V still a "normal" lens?

A: The Hasselblad XV Lens Adapter does not have any optics in the adapter so it does not affect the focal length of the lens. However, since the sensor in the X series cameras is smaller than 120 film. So an 80mm on a Hasselblad X would be closer to what a 100mm lens on the older 500C film camera sees.

Q: 8. IF I am say using a C500 series, why would I need this adapter? The back should work with the C500 Body right?

A: We are not aware of this working with the Canon C500.

Q: 9. Will this adapt my V series lenses to the 907X?

A: Yes.

Q: 10. Does this adapter allow for full aperture control using the Xpan lens?

A: The adapter is fully manual and does not transfer the electronics from a lens. The Xpan lenses have an F/stop ring so from the lens you will be able to change the aperture.