This Novoflex Negative Mask is meant for 6 x 4.5cm format and can be used to effectively mask out light when scanning film with the MS-FILMCOP holder. The mask has an anti-static finish that helps keep the negatives dust-free.

Mask for Film Holder    Weight: 0.04 lb    For Use with MS-REPRO and MS-FILMCOP

Related Questions and Answers

Q: 1. What is the footprint of this unit, the length and width?

A: We guess that it is slightly smaller than its box which is 10.0 x 4.6 x 1.2".

Q: 2. Will this work for individual cut 6x8 and 6x9 negatives?

A: Yes it is compatible with a single negative. It has a Maximum Scan Area of 7.2 x 2.3" / 184 x 58 mm.

Q: 3. I usually cut 6x7 film into strips of 3 (with 1 extra frame at the end), but this will not fit in some holders if they are not open on one end for the film to extend out. Will this holder allow for a film strip that is wider than the holder without pinching/creasing it?

A: No, this Lomography DigitaLIZA 120 Scanning Mask only has a scanning area of: 7.2 x 2.3 inches (184 x 58mm). While it does not define the frames individually, so you can scan overlapping exposures, doubles, triples, and panoramas. It does not allow anything larger than the given scanning area.

Q: 4. will this work with a canon 8800f?

A: Yes, it will. This mask will work with any flatbed scanner with enough wide film scan area.

Q: 5. Can I use the 35mm Film Scanning mask to hold film on a light table while I do a camera scan?

A: Yes, that should work.

Q: 6. Will it hold full uncut rolls?

A: Yes, the following item allows scanning the whole negative strip.

Q: 7. Compatible with 116 negatives?

A: Unfortunately, we cannot guarantee that the Lomography DigitaLIZA 120 Scanning Mask will work with the (now discontinued) 116 film format. The Lomography DigitaLIZA 120 Scanning Mask is designed for use with 120 film, which is 60mm wide, whereas 116 film is 70mm wide. Due to the larger size of the 116 film, we cannot guarantee the Lomography DigitaLIZA 120 Scanning Mask will work with this film stock, and your results may vary.

Q: 8. Does it work with Epson L3150?

A: No this will not work with the Epson L3150. This scanning mask can only be used with scanners that have a backlight/transparency unit. Most all in one printers like the L3150 do not have light in the lid to allow for this.

Q: 9. Will this work with an Epson v800 scanner? I need to scan Kodak 126 instamatic film and my 35mm holder cuts off the top because the image is off-center. This claims to image the holes as well, which sounds promising. But it also appears opaque in the pictures -- how does it let the light through?

A: Yes this will work with the V800, I use mine with the V850. The holder comes with removable center sections that with help load your film. Once the film is in and the edges are held in place you remove the center section and this allows light to pass through. There is no anti newton shield on these like our V800 holders. You may need to use scotch tape to space your holder up a bit to get proper focus as I did with mine.

Q: 10. will this work with a canoscan 9000f?

A: The requirement by Lomography is that the scanner have a backlight. the Canon Scan 9000f has a backlight so we say you are good to scan.