This 2-pack of gray Vicoustic VicDisplay Guitar is presented with a holder support, created to be used for a guitar instrument and designed to be fixed to the wall with screws. This fits perfectly in the guitar or bass stand category of any professional music equipment store.

Combo Acoustic Panel and Guitar Holder

The Grey and the exquisite Torino Red, exclusive for this product, are made with VMT, whilst the Black is developed from Black PET, with the added value of having the sides also in black.

Related Questions and Answers

Q: 1. Hey! I have a Sennheiser MD 46 dynamic microphone. Do you know if the preamps in the linkflex-ad2 are good enough to use with this dynamic microphone? I would like to use the linkflex to connect the MD 46 to an iPhone (and possibly my good old Zoom H2). Would that work?

A: The Linkflex specs show up tp 20dB of gain. which may be enough gain, depending on your subjects volume level. One question is, how much electronic noise will be added to the signal? Another question is, how will the MD46 sound if you must turn the Linflex up to full level on its level control. A big part of how a microphone will sound, is the impedance of the mic pre (the Linkflex) amplifier. The noise spec is not listed in the spec sheet, so I would be weary of this. It may be a lot to include, but this is the reason these; Cloudlifter CL-1, are included in the signal chain with dynamic mics, to improve, not only gain, but performance... Comica Specs: Comica Audio LINKFLEX-AD2 Specs General In-Line Accessory Type Pre-Amplifier Gain Up to +20 dB Connectivity I/O 1 x 1/8" / 3.5 mm TRRS Male Output 1 x 1/8" / 3.5 mm TRS Female Headphone Output 1 x Combo XLR-1/4" TS Female Mic/Hi-Z Input Performance Frequency Response 20 Hz to 20 kHz ±1 dB THD+N 0.02% (2-Kilohm Load) '

Q: 2. I would like to know the delay between the audio signal and the signal you hearIs there a delay or not?

A: No perceptible delay with mine. I haven't tried to measure it.

Q: 3. What is the diameter of the microphone clip?

A: About 2 inches.

Q: 4. how long is the xlr/usb cables included with this product?

A: USB is approximately 7 ft. and XLR is approximately 10 ft.

Q: 5. Does this work with usb-c if I have a usb-a to usb-c cable?

A: Using the included cable, into a USB A-to C adapter, this mic should work into a the computer.

Q: 6. I'd like to begin a podcast and interview guests. If I get two, can I plug both directly into my computer for recording purposes?

A: Both GarageBand and OBS can be set up up to record multiple USB mics.

Q: 7. How do I choose which frequency spectrum would be best for my application?

A: It depends.. if you are in a rural area it does not make much of a difference, however, if you are in an urban or suburban area you may want to consult the Shure Frequency Finder: https://www.shure.com/en-US/support/tools/frequency-finder

Q: 8. Can you hold it on your hand

A: Yes you can hold the Samson Q2U microphone in your hand.

Q: 9. Hey! I have a Sennheiser MD 46 dynamic microphone. Do you know if the preamps in the linkflex-ad2 are good enough to boost this dynamic microphone? I would like to use the linkflex to connect the MD 46 to an iPhone (and possibly my good old Zoom H2). Would that work?

A: As previosly answered: 6249490Approved The Linkflex specs show up tp 20dB of gain. which may be enough gain, depending on your subjects volume level. One question is, how much electronic noise will be added to the signal? Another question is, how will the MD46 sound if you must turn the Linflex up to full level on its level control. A big part of how a microphone will sound, is the impedance of the mic pre (the Linkflex) amplifier. The noise spec is not listed in the spec sheet, so I would be weary of this. It may be a lot to include, but this is the reason these; Cloudlifter CL-1, are included in the signal chain with dynamic mics, to improve, not only gain, but performance... Comica Specs: Comica Audio LINKFLEX-AD2 Specs General In-Line Accessory Type Pre-Amplifier Gain Up to +20 dB Connectivity I/O 1 x 1/8" / 3.5 mm TRRS Male Output 1 x 1/8" / 3.5 mm TRS Female Headphone Output 1 x Combo XLR-1/4" TS Female Mic/Hi-Z Input Performance Frequency Response 20 Hz to 20 kHz ±1 dB THD+N 0.02% (2-Kilohm Load)

Q: 10. The XSW-D can process Electric Bass sounds?

A: Yes, this system can be used with Bass Guitar.