The 3' Composer Series XLR Microphone Cable from Gator has an XLR male connector on one end and XLR female on the other. This Composer Series cable has a fine stranded 99.99% oxygen-free copper conductor with braided shielding. Featuring low capacitance, the cable allows more signal flow and avoids frequency roll-off. Other features include a chuck-style strain relief cable clamp for secure wire connections.

XLR Male to XLR Female Connectors    Low Capacitance    Oxygen-Free Copper Conductor    Chuck-Style Strain Relief Cable Clamp

Related Questions and Answers

Q: 1. Is this Mic compatible with the Canon G40?

A: Yes. You will use the XLR to Mini transformer cable that is part of the kit.

Q: 2. Does the NTG-2 have a db pad? Like a -10db switch?

A: No, the RODE NTG2 Shotgun Microphone does not have a -10 dB pad, but it does have a switchable high-pass filter set at 80 Hz which can be used to remove low frequency noise that is not part of your intended source.

Q: 3. Does a windscreen come with this mic?

A: It comes with a standard foam cover, which is not designed to block wind interference. You'll want to get a 'windscreen' also known as a 'deadcat' for a shotgun mic to reduce wind pickup.

Q: 4. How do I know if the mic is on?

A: As soon as you put the battery in then it's turned on. You'll need to monitor it some how, either with headphones or some kind of battery level display. I always take the battery out after i'm done using the mic for a day because if not it will just drain the battery dead in storage because it's always on. What I do is I hook the mic up to my zoom H1. You just need a small XLR to 1/8th input and then you're able to monitor the levels with headphones attached to the zoom H1. I hope this helps.

Q: 5. Can I leave the AA battery in or do I need to remove it when I'm done recording?

A: You can leave a AA battery inside of the RODE NTG2 Shotgun Microphone as long as you will be using the mic again within a few days. Otherwise, it is always best to remove the battery from an electronic device that will not be used for a while in order to prevent damage from problems caused by the battery leaking.

Q: 6. Can this be connected to a iPhone 6s Plus?

A: Yes but you will need the SC4 TRS to TRRS adaptor. a href= http://www.rode.com/accessories/sc4 target= _blank http://www.rode.com/accessories/sc4/a

Q: 7. Does the Rode NTG2 have an on/off switch?

A: The Rode NTG-2 features no on/off switch. It is recommended that you remove the batteryfrom the unit when the microphone is not in use as it is always drawing current.

Q: 8. Does the included shockmount work with traditional threaded pole conectivity? or is it only made for camera mounting?

A: According to the info listed there is a 3/8 -16 thread connection at the base.

Q: 9. Does it comes with some kind of box or something for the hole Kit?

A: No, everything is separate. So you need to get a case or a bag if you want to have eveything neatly stored.

Q: 10. So with my black magic camera as long as i have the battery in the mic i won't need phantom power correct?

A: Yes, this is correct. It will run out quite quickly. Between 4-6 hours.