The 590nm, 52mm Kolari Vision Pro Gen 3 Infrared Lens Filter is fitted with precision machined brass rings, enhanced grip, and a superior lifetime warrantied construction while maintaining a low profile over your lens. This external infrared filter is perfect for adding to a full-spectrum conversion or on top of another infrared conversion to get a different effect. The filter features a hydrophobic AR coating that increases scratch resistance and causes dust, smudges, fingerprints, water, and even permanent marker to slide right off its surface with minimal effort. The brass ring construction features front and rear threading and an aggressive grip knurling for easier filter removal.

High-Transmission IR Glass    Anti-Reflective, Anti-Smudge Coating    Front and Rear Threaded Slim Brass Ring    Aggressive Grip Knurling

Related Questions and Answers

Q: 1. Will a lens cap fit if this lens hood is on a Nikon Z 28mm 2.8 ?

A: The Sensei PRO 52mm Wide Angle Aluminum Lens Hood is compatible with the Nikon NIKKOR Z 28mm f/2.8 Lens.

Q: 2. Can I still use a 52 mm snap-on lens cap if this is installed on a NIKKOR 50mm f/1.4D?

A: This hood lacks a thread on the inside to accept a 52mm cap. It would have to be removed when not in use.

Q: 3. This is listed as a good accessory for the Nikon 40mm f/2 lens. Has anyone tried it to see if it vignettes on that lens?

A: The Sensei PRO 52mm Aluminum Lens Hood will fit but has yet to be tested on the Nikon NIKKOR Z 40mm f/2 Lens. The Vello LHN-HN52 Dedicated Lens Hood (52mm Screw-On), BH #VELHNHN52, is a better option.

Q: 4. When powering the camera off, does the 40 f2 close down its aperture blades? Mine stays open or at f#. Asking re: dust sealing

A: The Nikon NIKKOR Z 40mm f/2 (SE) Lens would not close the aperture blades when a camera is powered off. A camera's dust sealing has no relation to the closing of aperture blades as aperture is inside the lens; there is no way to fully close apertures blades.

Q: 5. Will this fit the new Nikon Z 28mm f2.8?

A: Yes.

Q: 6. Would this fit on a 50mm 1.2 ais Lens ?

A: The filter size of the 50mm 1.2, is 52mm, so yes it will fit.

Q: 7. Will this hood screw into my Hoya 52mm UV lens which is on my Canon 40 mm 1.8 lens?

A: Yes it will. However on that lens you might experience some vignetting.

Q: 8. Is this lens hood reversible? I would like to use this on the Fujifilm XF 35mm f/1.4 R lens (53mm equivalent).

A: Unfortunately, the Sensei PRO 52mm Aluminum Lens Hood is not reversible.

Q: 9. Where is this lens manufactured?

A: The Nikon NIKKOR Z 40mm f/2 (SE) Lens is manufactured in Thailand.

Q: 10. I have a Fujifilm X-T100 and I'm wondering if this would work along with the Hoya 52mm Digital Filter Kit II? I currently have the Fujifilm XC 15-45mm lens.

A: Yes, you can use this hood with 52mm filters. Screw in the filter then screw in the hood.