This small Hydra Alien Suction Cup from Tilta is a replacement unit for the one that comes with the Hydra Alien Car Mounting System, but it can also be used as an expansion accessory to the original rig. It works with any Hydra dovetail plate and can be easily placed in multiple positions to accommodate the majority of vehicles. The aluminum, stainless steel, and rubber suction cup can handle payloads of up to 110 lb.

Payload Capacity up to 110 lb    Works with Hydra Dovetail Plates    Accommodates Majority of Vehicles    Aluminum, Steel & Rubber Construction

Related Questions and Answers

Q: 1. will this work with the ronin-m? or ronin 2?

A: No it will not this is designed for the New Ronin RS 2 and is part of the Tilta DJI Ecosystem for the new DJi gimbals

Q: 2. will this work with the ronin-m and ronin 2?

A: No it will not this is designed for the New Ronin RS 2 and is part of the Tilta DJI Ecosystem for the new DJi gimbals

Q: 3. What are the best stiffness settings for using it with an A7SIII with a lighter lens?

A: The Tilta Hydra Alien Car Mounting System (V-Mount) does have settings for payload weight. It is up to the you to set the weight of the payload by adjusting the pressure of the arm, Tilta does not have pre-set stiffness settings on the arm, unfortunately. I would recommend generally using a bit heavier setup to achieve a more stable image.

Q: 4. What is the load capacity?

A: The payload for the Hydra Alien is roughly 15 to 18 pounds.

Q: 5. Is a gimbal required

A: The Tilta Hydra Alien Car Mounting System (V-Mount) is just a mounting solution. It does not include a gimbal with the kit. This system is compatible with the DJI RS2, RS3, RS3 Pro, RS4 Pro, Crane 3S, Ronin 4D and any other gimbal that can mount via 1/4″-20 screws and power via D-Tap or internally.

Q: 6. Bag?

A: Yes, a Waterproof Hard-Shell Safety Case is included.

Q: 7. What kind of adapter is needed for this to work with the DJI Ronin m?

A: The Tilta Hydra Alien Car Mounting System (V-Mount) is compatible with any gimbal that can mount via 1/4″-20 screws and power via P-Tap.

Q: 8. Can you flip the bottom bar so the nato rail and rosette are on the opposite sides? Nato right. Rossette left.

A: The bottom bar of the Tilta Hydra Alien Monitor Bracket can be switched to either side.

Q: 9. Will the rs3 (non pro) fit on this?

A: Yes, the Tilta Hydra Alien Car Mounting System (V-Mount) is compatible with the DJI RS 3, RS 3 Pro, or RS 2.

Q: 10. Can it use the RS4 Pro Rs4 ?

A: Yes, the Tilta Hydra Alien Car Mounting System (V-Mount) will also support the DJI RS4 and RS4 Pro gimbals.