Constructed from sturdy aluminum, the 8', black-finished DT-GP8 End Plate Square Truss Straight Segment from Global Truss has support braces and four tubes that align with the studs on optional base plates to allow the segment to be freestanding.

Aluminum Construction    Length: 8'    Weight: 47 lb

Related Questions and Answers

Q: 1. Is this generation 2 telescope?

A: Yes it is!

Q: 2. When assembled, what is the height of the eyepiece from the ground?

A: It's surprisingly low for such a large-aperture scope. Pointed straight up at zenith, the eyepiece is at eye-height for me, 67 inches. At horizon, the eyepiece only about 20 inches off the ground.

Q: 3. How is this arm compared to the GVM360 boom arm?

A: The GVM360 offers a better locking system. The the impact unit and includes stand with purchase.

Q: 4. Could the Boom Arm hold the Amaran 300c RGB LED Monolight with an Aputure Lantern 90 (3') attached to it?

A: The Impact Boom Arm (Chrome-plated, 86") at full extension is not strong enough to hold the Amaran 300c RGB LED Monolight with an Aputure Lantern 90 (3') attached. The setup is over 8 lb and the boom at full extension supports no more than 8 lb.

Q: 5. Does it come with a 5/8"-27 male threaded end for a microphone clip or an adapter for that?

A: No, the Impact Boom Arm would have a 5/8" stud for lighting. To allow for a microphone to fit, you can use the CAMVATE 5/8" Light Stand Head with 5/8"-27 Screw for Microphone Clip Stand, BH # CAC2950. http://bit.ly/3AlsoVd

Q: 6. What's the diameter of the wheels on this dolly?

A: The diameter of the wheels for the Sirui DT-06 Tripod Dolly is approximately 3".

Q: 7. Can I use this to hang a F34 truss segment from the ceiling using hooks through the fish eye part?

A: The Kupo X-Pro Eye Clamp M12 fastens around F31, F32, F33, and F34 truss sections and tightens down via a bolt and wing nut. A large eyelet supports gear weighing up to 1650 lb.

Q: 8. Can I change the focuser's position to opposite side of a tube?

A: No, you cannot.

Q: 9. Can this be mounted 90 deg vertically to extend the height of a C-stand etc? If so, will it be stable at full extension?

A: It will be slightly off axis, but it can be used vertically. The stability will depend on the stand it is used on.

Q: 10. sandbag?

A: No, we suggest the following sand bag Impact Filled Saddle Sandbag (15 lb, Black) BH #IMSBFB15 • MFR #SBF-B-15 https://bhpho.to/3lreNYe