Mount your antennas remotely and get better reception from your wireless system with this 500' LMR400 UltraFlex Antenna Extension Cable from ClearOne. This 50-ohm, low-loss, non-plenum cable features male TNC connectors at both ends for quick and easy connection and is a drop-in replacement for RG-8/9913 air-dielectric-type cabling. The cable can be used for jumper assemblies in wireless communication systems and supports applications that require periodic/repeated flexing.

For Remote Antenna Mounting    Replacement for RG-8/9913 Air-Dielectric    50-Ohm, Non-Plenum, Low-Loss Cable    TNC Male Connectors    Supports Periodic/Repeated Flexing

• LMR400 UltraFlex has a stranded center conductor and rubber outer jacket designed for multiple bending/flexing cycles. It is used for both indoor and outdoor applications.
• Flexibility and bendability are hallmarks of the cable design. The flexible outer conductor enables the tightest bend radius available for any cable of similar size and performance.
• Low loss is another hallmark feature of LMR400 UF. Size for size, LMR has the lowest loss of any flexible cable and comparable loss to semirigid hard-line cables.
• RF shielding is 50 dB greater than typical single shielded coax. The multi-ply bonded foil outer conductor is rated conservatively at >90 dB (i.e. >180 dB between two adjacent cables).
• LMR400 UF cables are designed for outdoor exposure and have a life expectancy in excess of 10 years.

Related Questions and Answers

Q: 1. Will this work on a Teradek Ace 800 TX ?

A: Yes, The Teradek Wireless Antenna for Bolt 500/1000 Tx & Rx, Bolt 3000 Rx 2db antennas will work.

Q: 2. What port does the cable for this unit go into the hollyland mars t1000 coms system?

A: the following unit plugs does not plug into a port but extends your wireless transmission frequency range when using the SYSCOM 1000T or Mars T1000 intercom transmission systems with this Extension Panel Antenna from Hollyland.

Q: 3. Since the Syscom T1000 is a full 8 pack system, does that mean I have to buy 2 of the Extension panels to support all 4? Cause it says the extension panel only support 4 belt packs. Also, could I use the extension panel and still use the antennas that come with the Syscom t1000 together?

A: Yes, two of the Hollyland Extension Panel Antenna for SYSCOM 1000T/Mars T1000 would be required for full coverage of all components in the Hollyland Syscom 1000T-8B Full-Duplex Intercom System with Eight Beltpacks and Headsets. The Extension panel would replace the standard antennae used in the system and would connect to the same antenna input connections on the base station's back panel using the provided Communication Cable.

Q: 4. Thanks for the prompt answer. Outdoor meaning also that the Panel Antenna can operate under rain, snow and other weather conditions? We are not sure if the enclosure of the Panel Antenna is sealed against rainwater ......

A: This has no rating listed for outdoor use.

Q: 5. How many MIC does the ChatAttach 150 comes with?

A: The ChatAttach 150 comes with two speakerphones. Each one has three microphones in it to giv 360 degree coverage.

Q: 6. Do I connect both SMA connections to the base station or is one a pass-thru?

A: Yes, both SMA ports on the Hollyland Extension Panel Antenna do need to be connected to the base station.

Q: 7. Are both of the ports meant to connect to the receiver, or is one a "thru" which can be used to extend the signal range by connecting another antenna?

A: One port is for connection to the SYSCOM 1000T or Mars T1000 base station using the included cable and there are two RP-SMA male mounts on the bottom which can be used to add optional antenna extensions for an even more stable transmission.

Q: 8. So two different answers on the compatibility with the bolt XT. Can somebody confirm if this can work on it or not? One of the answers left a link to a discontinued item

A: This is compatible with the Bolt 500 XT. According to Teradek part number 11-0022 is the correct antenna.

Q: 9. would this work with solidcom C1 hub base?

A: The Hollyland Extension Panel Antenna is not listed as compatible with the Solidcom C1 Hub.

Q: 10. is this a male or female connector?

A: This is a female connector.