The 10' Rocstor DisplayPort 1.4 Cable allows you to connect your DisplayPort devices with HBR2. Supporting resolutions up to 8K at 60 Hz or 4K at 120 Hz, this cable also supports HDCP and DPCP protocols to ensure digitally protected content is displayed properly. Additionally, the cable can support Multi-Stream (MST) for daisy-chaining multiple monitors.

2 Male DisplayPort 1.4 Connectors    Supports up to 7680 x 4320 at 60 Hz    Supports HDCP, DPCP & MST    10' Length

Related Questions and Answers

Q: 1. Is the USB 3.1 compatible with USB 3 and USB 2?

A: Yes, as long as you have the proper cable.

Q: 2. Is this a replacement cable or an extension cable?

A: Extension cable

Q: 3. is this the unit with Bluetooth and the Iphone app?

A: Yes, the miops app is available for both iOS and android and connect easily to the miops device allowing full control from your phone or tablet

Q: 4. Is the Miops camera trigger compatible with a Nikon D3200?

A: You would need the version with the MC-DC2 https://bhpho.to/2NT25Qv.

Q: 5. Does MIOPS support a programmed delay trigger?

A: Hi. I have used my MIOPS for shotting when a sound trigger.You can have a look to the MIOPS user manual that your can find at official web of miops.probably here you find a answer to your question.Regards /Jose Antonio

Q: 6. Will this trigger Nikon D3 camera ?

A: Yes, the Miops is fully compatible with the Nikon D3.

Q: 7. What type of laser is best for this: red, green, IR...? And what class: 2, 3b...? I'd want a laser strong enough, but without damaging the sensor.

A: According to the manufacture the color of the laser does not make any difference.There is no specific power for the laser Miops recommends. It depends on the situation. If you are outside and it is bright you most likely need a stronger one than one that is used inside.I have seen it used with a low end one from a stationary store. Again it all depends on distance and the light outside.

Q: 8. Would this trigger Nikon d3 camera?

A: You will need the correct cable for that MIOPS unit. I think your camera would need a PC terminal as well.

Q: 9. I want to use with Nikon D7200. Which one would be best for this model and which extendion cable would be best

A: N3 Cable

Q: 10. Is it possible to use this product photographing humming birds at a feeder using 2 flash units and a nikon d200. setup?

A: Yes the Nikon Miopis trigger kit with the 10 pin cable will work with the 200D and and flash units. You will need a trigger and receivers for your lights to fire them. And you can use the Mobile Dongle for iOS and Android should you want to use your phone to physically trigger the camera which will then trigger the lights.