Capture even more of your subjects and landscapes by adding the DJI Wide-Angle Lens for Mavic 3 Pro/Pro Cine to your drone. This lens covers the gimbal to increase the Hasselblad lens' 84° FOV to 108°, with a 15.5mm format equivalent.

For DJI Mavic 3 Pro & Mavic 3 Pro Cine    108° Field of View

Related Questions and Answers

Q: 1. Does this fit the Nikon 28/1.4D?

A: No, you need the 77mm one. https://www.bhphotovideo.com/c/product/1079788-REG/sensei_lhm_w77_pro_77mm_wide_angle.html

Q: 2. Is there a way to use ND filters once this wide angle lens is installed? Any DJI or third party solutions?

A: Unfortunately, the DJI 15.5mm Wide-Angle Lens for Mavic 3 will not allow users to add on filters at the moment.

Q: 3. Will it work with a 16mm lens on APS-C camera or only starting with 18mm?

A: Yes, it will work on any lens with a 58mm filter thread and should cause vignetting with 16mm apsc lens.

Q: 4. are all the automated modes (active track, Pont of Interest, etc...???) supported while in Pro Res recording mode?

A: FocusTrack cannot be used on the DJI Mavic 3 Pro Cine Drone when recording in any resolution of Apple ProRes 422HQ/422/422LT, resolutions of 5.1K and above, and 120fps and above.

Q: 5. Will this work with the Panasonic 12mm 1.4?

A: Yes it will work on 12mm f1.4

Q: 6. Will this fit the new Nikon Z 28mm f2.8?

A: Yes.

Q: 7. Can a filter be screwed onto the outside of the 52mm lens hood?

A: According to the manufacturer, the front opening of the Sensei PRO 52mm Wide Angle Aluminum Lens Hood can accept 72mm filters.

Q: 8. Hi, I want a metal lens hood for my Nikon F 24 f1.8 to avoid vignetting. Should I go for the 72 mm or 77 mm with stepup-ring, or something else? Best regards from Erwin

A: You may use the Sensei PRO 72mm Wide Angle Aluminum Lens Hood for a Nikon AF-S 24mm f/1.8 lens to prevent vignetting.

Q: 9. Will this work for a 6 x 4.5 medium format 60mm (@35 in 35mm format)???

A: If the lens has a 49mm front thread the hood will fit. But chances are you will get some vignette on the edges of the frame.

Q: 10. For the 58mm version of this hood, is it possible to use a 58mm pinch type lens cap inside of it? Also, will this cause vignetting on a 17.5mm MFT lens?

A: The 58mm pinch cap works fine. Filters, though you didn't ask about them, are a related issue to consider; you can't attach a filter inside the hood. You must either use 58mm filters behind the hood, or 62mm filters in the hood's front end (either or both could create a vignetting problem). I use this hood on a 6x4.5cm film camera lens, so I can't address vignetting on your lens.