The oak Hand Crank Standing Desk with 55" Tabletop from Mount-It! uses a manual hand crank to adjust the height between 30 and 50" so you can quickly go from sitting to standing. The solid steel frame supports weight up to 132 lb so you can easily fit your full setup on the desktop. For more space underneath the desk, the frame has 44 to 64" of width adjustment as well.

55 x 29" Tabletop    30 to 50" of Height Adjustment    132 lb Weight Capacity    Hand Crank Control    Solid Steel Frame

Related Questions and Answers

Q: 1. Does this come with a 5/8" Stud for mounting of a light?

A: Unfortunately no. The SmallRig Encore DT-30 Desk Mount with Holding Arm will only have two 1/4"-20 mounts.

Q: 2. Will this work with small rig mini follow focus?

A: The SmallRig does not define the nature of its accessory port and we have not tested this exact pairing. In general, the SmallRig devices are not entirely adhering to specific industry standards and we cannot confirm compatibility on such a device.

Q: 3. Can you tell me if this will fit the Kamerar FF-3 Follow Focus? Thanks

A: Like the Arri Hirth-tooth rosette and the 3/8 -16 tripod mounting screw hole, there is an industry standard for follow-focus extension connectors. That is, for the most part, the Arri 12x12mm connector. We have not tested this combination but we do not see anything to suggest this flexible follow focus extension will not work the follow focus you mentioned as intended. If you come upon a Panavision follow focus, however, that is 5/8x5/8 and it will not work.

Q: 4. How low can it be adjusted to? Trying to take pictures on the floor

A: The minimum working height of the 1818XL is 8.6".

Q: 5. How much weight can this support?

A: The VIJIM LS02 Camera Desk Mount with Auxiliary Accessory Arm can support up to 25 lbs, while the included auxiliary arm can support a maximum of 3.3lbs.

Q: 6. Can it still rotate when you have the legs extended?

A: You can rotate the top of the Oben ACM-2400L 4-Section Aluminum Self-Standing Monopod with Mini-Legs when the legs are extended.

Q: 7. Is the pan head removable so I can put a ball head on the legs?

A: I'm sorry, no, the head is not removable.

Q: 8. What is the weight limit for this mount?

A: The weight limit for the VIJIM LS02 Camera Desk Mount with Auxiliary Accessory Arm is 6.6 pounds on the main vertical pole mount, and 3.3 pounds on the horizontal accessory arm.

Q: 9. where does the strap attach on the camera top?

A: This strap attached to the strap lug on the right side of the camera.

Q: 10. Can you remove the clamp and if so is it threaded on?

A: No, the clamp on the SmallRig Encore DT-30 Desk Mount with Holding Arm is not removable.