The APC Integrated Rack LCD/KVM USB Cable connects your equipment to a KVM, giving you 10 feet of total length so you can easily route it around your cabinet. This cable features a VGA-to-VGA design with a USB-A male connector that plugs into your host device. Each VGA connector uses screws to lock them in place while in use and prevent accidental unplugging.

10' Length    VGA to VGA & USB-A Connectors    Screw Locking Mechanisms

Related Questions and Answers

Q: 1. Does this UPS have Automated Voltage Regulator?

A: Thank you for your inquiry. Yes the SMT1500RM2U would have Automated Voltage Regulation.

Q: 2. How does this differ from the SMX1500RM2U? Not sure what the difference is between SMX and SMT series.

A: The main differences are that the SMX has the option to add external batteries like the SMX48RMBP2U. The SMT series does not have these options.

Q: 3. If the USB cable should stop working, can it be removed?

A: The cable is installed during fabrication and can't be removed or replaced. If you happen to experience an issue with the integrated cable for some reason, we would encourage you to contact us at info@gradusgroup.com or 212-594-2120 within the 1 year warranty term to arrange warranty service.

Q: 4. What's the difference between this SMT1500RM2U vs the SMT1500RMUS?

A: The RMUS has a serial port. Load capacity is 1500 VA vs 1440 VA of the RM2U.

Q: 5. Can the XLR cable be easily removed?

A: Yes, the XLR cable can be removed (and replaced, if required), though it may not be an easy task.

Q: 6. we used this but when we used this have beep sounds sometime . can i help you?

A: Thank you for your interest in our products. It really depends on what type of beep it is. When the UPS is on battery it will four beeps every 30 seconds. If the battery has failed in the unit it will emit short beeps for one minute. The replace battery light would be lit on it as well if that is the case. If it isn't of these beeps please do not hesitate to reach out to an APCbySchneiderElectric support team for further assistance. We offer email and chat services through our support site. For the fastest service visit our chat at https://www.apc.com/us/en/tools/chat/.

Q: 7. How loud is this unit under normal operation? Would you use it in your home?

A: It isn't overly loud. It would depend. If you have a separate room that you are using it in I would say yes, but in a common area you would still have a steady hum. APC's website should give you a db level.

Q: 8. Does this include the permanent desk mount shown in photo? (Or just clamp)

A: Yes. There are two mounts included with the BA-XE4. One is the C-clamp mount and the other is the permanent flange mount.

Q: 9. Is the threaded microphone mount male or female?

A: The Auray BAI-2U Two-Section Broadcast Arm with Internal Springs and Integrated USB Cable has a standard 5/8"-27 male threaded mounting point to attach a microphone.

Q: 10. I'm sorry, I should have clarified my last question - I was asking if the stud/spigot that mounts to the base clamp is 5/8" in width? I'm planning on using a different clamp with a 5/8" receiver. (BH#SACSGC) Thank you.

A: The base stud/spigot is not specified.