The black Hosa Technology's Dual Banana Male to Dual Banana Male Speaker Cable (Zip) is a 3' cable that is designed to provide performance with its high-quality components and is intended for high-current applications, not line-level signals.

Oxygen-Free Copper (OFC) conductors for lower resistance

Zip-style jacket for low visibility and ease of termination

Intended for high-current applications only, not line-level signals

Related Questions and Answers

Q: 1. how long is the length of cable from the XLR connectors to where they meet?

A: Hi Greg, the length of cable between the XLR connection to where they both meet is approximately 16 inches.

Q: 2. What about 48volt phantom power? Do the mics still get enough juice?

A: The Hosa Technology YXM-101.5 XLR Female to Dual XLR Male Audio Y-Cable is not designed to split signals from microphones directly and therefore may not provide adequate power to a microphone requiring 48 volts.

Q: 3. Will this cable connect the Audient Id4 output to iLoud micro monitor speakers?

A: Yes, the Hosa Technology HPR-005X2 Dual 1/4" TS Male to Dual RCA Male Stereo Audio Cable can be used to connect the outputs of the Audient iD4 MKII Desktop 2x2 USB Type-C Audio Interface to the inputs of the IK Multimedia iLoud Micro Monitors.

Q: 4. ... each TRS connecter in this cable??

A: Hi Jose, The two "Y" ends of this cable meet in the center. In the case of the 6-foot cable, they would meet roughly at 3 feet. This was a change we made after the product was released. That means models that were previously purchased may be different and have a shorter split. Thank you for considering Hosa for your connectivity needs. Best regards, Hosa Support Team

Q: 5. Is this a 3 wire cable?

A: No. Think of it as a dual monaural.

Q: 6. Does this cable allow for both L/R channels to remain separate (allowing a L/R panned mix to stay L/R when input to a DSLR)?

A: Yes, it's designed to take a stereo signal and split it into separate L&R outputs. Best regards, Hosa Support.

Q: 7. My JBL audio speakers are separated 43 inches approx. What is the distance between each TRS connecter in this cable??

A: This cable will not seperate this will not work with your speakers setup

Q: 8. Can you extend the 1/4" plug with a female to male 1/4" extension cable? If so, how long can it be?

A: Yes. you can use extension cables for the 1/4" TS connectors. The maximum length of the extension cables would really depend on what type of devices you will be connecting from and to. Up to 25' could be OK if you use good quality cables.

Q: 9. how long is the length of cable from the XLR connectors to where they meet?

A: the 6' cable splits in half (3') where the mini plug end breaks into the 2 xlrs

Q: 10. can i use this to connect the Scarlett 2i2 3rd gen interface to an Onkyo A/V receiver?

A: Yes, that is the correct cable for connection.