Safely and effectively remove debris from power lines or handle various agricultural land management tasks with this FT10 Spitfire Flamethrower for DJI Matrice 300/350 RTK from CZI. Once attached to the drone, simply adjust the nozzle direction and fill the tank with 95% alcohol fuel. If needed, use the integrated green laser-guided aiming system to target where the flame will hit. Once triggered, the fuel mixes with air, is ignited by a wind-resistant, high-voltage electrical arc, and is projected from the nozzle. When you stop the stream, fuel dripping is prevented by the nozzle valve.

For DJI Matrice 30 Series Drones    Land Management & Power Line Cleaning    Green Laser-Guided Aiming System    Wind-Resistant High-Voltage Arc Igniter    CO2-Powered Flame    Adjustable Pressure from 9.8 to 23'    Nozzle Valve Eliminates Fuel Dripping    Made to Not Block Drone Sensors    Upgradeable Control Box System

• CO2-powered flame
• Adjustable pressure from 9.8 to 23'
• Up/down nozzle adjustment +/- 15°
• Left/right nozzle adjustment +/- 20°
• Made to not block drone sensors
• Upgradable independent control box system

Related Questions and Answers

Q: 1. What is the maximum HDMI cable length that can be used on the output side (e.g. 50 ft, 100 ft)?

A: HDMI cables tend to only work for around 25 feet. For longer runs you would need to pair this unit with an HDMI Repeater such as BH #TEHDREPT4K. https://bhpho.to/2XKwSDJ

Q: 2. What's the latency introduced by the splitter?

A: The splitter itself should not introduce any extra latency. // Also, if there are any other technical or product related questions, feel free to contact us directly at any time at support@dracobroadcast.com.

Q: 3. To clarify this will create two extra sources?

A: It will only create 1 additional source. You would connect 1 HDMI input and it would give you 2 HDMI outputs. It will take you from 1 to 2 HDMI outputs.

Q: 4. Is there any compatible quick release plate adapter for this one?

A: i have a vidprott-900 stand will it fit

Q: 5. Will this fit in the manfrotto 577 quick release adapter?

A: It will not fit.

Q: 6. Is the VT-QRP Quick release plate compatible with the ball head on the DXM-1000 or DXM-500 Monopods?

A: The Magnus VT-QRP30 will to be compatible with the DXM-1000 or DXM-500 monopods.

Q: 7. Hello, what are the BASE dimensions of this quick release?thank you, Charlie

A: Side that mates to the camera: 3.135 x 2.040 . Screw and pin protrude 0.175 .Unit is 0.565 thick.Side that mounts to the tripod: 1.864 x 2.667 , plus tabs centered on both of the long sides that measure 1.351 x 0.175 each.Hope this helps.

Q: 8. Will this fit my Canon Deluxe 300 tripod?

A: It appears the Sunpak Quick Release Plate with Bubble Level, B&H # SUQRPUP777, is listed as the correct quick release plate for use with the Canon Deluxe Tripod 300.https://bhpho.to/2k8OAK3

Q: 9. This item support HDR?

A: This supports up to UHD 4K, not HDR.

Q: 10. does this thing require power or can be powered via HDMI cable?

A: Mine came with a brick that plugs into the wall. 5.0 V at 1.5 A