The matte gray Schoeps CMC 1 U is a miniature Colette Series microphone amplifier offering uncompromising high fidelity in a lightweight and ultracompact form factor for studio recording, broadcast, and live stage applications. Presented as an alternative to the renowned Schoeps CMC 6 amplifier, the CMC 1 U is compatible with all existing MK mic capsules and Colette active accessories (all available separately).

It features a balanced XLR output, compliance with 12 or 48V phantom power, and low current consumption. Its Schoeps RFI Shield provides high immunity from RF interference for a clean, low-noise signal. The CMC 1 U supports the high maximum SPLs tolerated by the various MK mic capsules (available separately).

For Close-Miking Instruments    Two MK 21 Wide-Cardioid Matched Capsules    Two CMC 1 U Miniature Mic Amplifiers    Two SG20 Stand Clamps    Compact Peli Case    XLR Output Connector    High Immunity from RF Interference    Operates on 48 or 12V Phantom Power

• Complete alternative to the renowned CMC 6 amplifier
• Can be used in place of the CMC 6 with no compromise
• XLR output connector
• Electrical characteristics of the CMC 1 U are equal to, or even better than, those of the CMC 6
• 1.4" long (about a third the size of the CMC 6)
• 1.3 ounces (about 40% lighter than the CMC 6)
• Fully compatible with all existing MK capsules and Colette active accessories such as the CUT 60 and RC tubes
• Very high immunity from RF interference with the Schoeps RFI Shield
• Includes mic clip for easy attachment to a mic stand
• Suspension mounts such as the Rycote INV-6 are available separately

Related Questions and Answers

Q: 1. Will this fit a Schoeps CMC641?

A: No, this kit is for use with the Schoeps MiniCMIT microphone. The Rycote Windshield Kit 2 - Complete Windshield and Suspension System (B&H # RYWSK2) is the kit that fits the CMC641.

Q: 2. Would this Rycote Windshield Kit accommodate the DPA 4017C combination?

A: Yes, this will be compatible. The 4017C with preamp is just slightly longer (0.12") than the CMIT mini.

Q: 3. Will this spray give additional UV fade protection to a type C print, such as Fuji Crystal Archive?

A: Yes, the Moab Desert Varnish Lacquer Spray (B&H# MODVLS) spray is designed to reduce the amount of UV light reaching the photo upon which its applied. That will lend additional UV-induced fade protection to the print.

Q: 4. Can anyone help me find a metal rod for this that can hold 9' muslin backdrops?

A: The Impact Cross Pole for Uncored Paper or Fabric Backgrounds (106.3") can accept the Impact drive at each end to support a 9 foot muslin background. https://bhpho.to/3mzxJRl

Q: 5. what do I need to make the VND filter?

A: You need two circular polarizers.

Q: 6. This system says it has a 22 lb load capacity, but each 9 foot roll weighs about 14 lbs. Will this system support 3 full rolls at once?

A: Yes i always keep 3 rolls attached. Just make sure you properly install the brackets to get the full strength.

Q: 7. I have this product, but find that paper rolls want to just keep unrolling. Is there a way to increase tension on the chains to keep this from happening?

A: The white section of the Impact Varidrive Drive expands to keep the paper from unrolling. To expand the Impact Varidrive Drive, you should be able to turn the black knob on the end of the device while the white section is inside the seamless paper's core to expand it until it is snug to prevent the paper from unrolling while in usage.

Q: 8. Will this work with Wooden Camera UMB-1 matte box?

A: no this will not work with the Wooden camera matte-box

Q: 9. Will this work with the bright tangerine VIV matte box? Thanks.

A: No, the Bright Tangerine ONE Tray for Misfit Kick or ARRI LMB Matte Box will not work with the Bright Tangerine VIV matte box. This tray requires two slots.

Q: 10. Once this is set up for a 107-inch roll, is there any way to use a shorter roll in the future or are you committing to one length of roll forever?

A: Yes, but it might be more work then you might what to do. Use an empty 107 roll and reroll onto the 107 roll the smaller size that you would like to use.