Use this 19.7" Teradek RT Control Cable for Sony F55 Camera from DigitalFoto Solution to add run/stop control to your Teradek RT system when using an F55. This cable has a straight 4-pin LEMO-type connector on one end and a straight 4-pin Hirose connector on the other.

For Teradek RT Follow Focus System    For Sony F55 Camera    4-Pin LEMO to 4-Pin Hirose Cable    Run/Stop Control, 19.7" Length    Straight Connectors

Related Questions and Answers

Q: 1. Will this work with the Sony Venice ?

A: Yes, since the the Sony F5/F55 have the same 4-pin Hirose port as the origional Venice, the Tilta Nucleus-M Run/Stop Cable for Sony F5/F55 Cameras will work with the Sony VENICE 6K Digital Motion Picture Camera (BH #SOMPC36101).

Q: 2. Is this the same as the pro II

A: No, the DigitalFoto Solution Limited TRINIPOD Carbon Fiber Monopod Sled and Yoke Collar System is not the same as the DigitalFoto Solution Limited THANOS-PRO II Gimbal Support System, which is a higher-level system.

Q: 3. Is the end of each arm a nato rail / the same as the DJI RS cold shoe?

A: The only mounting points on the DigitalFoto Solution Limited Dual Z-Axis Spring Handles & Tethered Control Adapter for DJI RS 2/3/3 Pro are the two 1/4 20 female screw points at the top of each handle. Unfortunately, there are no NATO rail mounts on the handle.

Q: 4. If this has a maximum torque of 1.2nm, does that mean it's less responsive than the mk3.1 and motr.x?

A: Yes, the Teradek RT MOTR.S Max Lens Motor does have less torque than the MK3.1 and MOTR.X. However, the tradeoff is that this is faster.

Q: 5. What is the circumference or diameter of the inside circle?

A: The inside diameter of this product is not listed. That is because it is specifically designed for the Ronin-S or Crane 2 Gimbal and will have the proper dimensions to work with this product.

Q: 6. Do these work with the mdr.s?

A: As far as we know the Teradek RT Thumbwheel S Standard Wired Controller only works with Latitude or MK3.1 systems.

Q: 7. are the rosettes at the base where the handles connect proprietory?

A: The handles of the DigitalFoto ARES Z AXIS uses custom rosette like connections.

Q: 8. What is the load capacity on this new version?

A: 11 pounds

Q: 9. Will the clamp work on the DJI Grip for Ronin 2 (30 mm)? Same size as Movi Pro ring. Or is there an alternative clamp?

A: Yes, this should clamp to the DJI Grip for the Ronin 2.

Q: 10. Does it include a clamp to fit on a Zhiyun crane 3S?

A: This is compatible with a variety of gimbals including the Crane 3S.