The X Modular Yoke with Spigot from ARRI allows for the attachment of X22 and X23 modular frames. The silver aluminum yoke weighs 6.1 lb and includes a 28mm spigot. Shock absorbers are integrated to reduce impact in rugged environments.

For X22 & X23 Modular Frames    Aluminum Build    28mm Spigot

Related Questions and Answers

Q: 1. Hi Guys, this picture does not seem to reflect a double ended spigot with male threads on either side. Can you verify that the photo is accurate? thank you

A: It doesn't. Male one one end Female on the other

Q: 2. Is this good for elinchrom mono light?

A: This stand would be fine for holding an Elinchrom monolight lower to the ground.

Q: 3. How long is the 5/8 pin side??

A: The 5/8 stud side is 1 3/4" long.

Q: 4. What is the hole for in the spigot?

A: I've used the hole a few times to tighten, using a screwdriver or hex wrench. Avoid excessive tightening.

Q: 5. Would I be able to mound a tripid head/ball head to the spigot in order to attach a camera at the end of it?

A: Yes , this has 1/4"-20 and 3/8" threaded ends standard for most ball heads

Q: 6. What is the distance between the two sets of mounting holes? Would these work with the rear mounting points of the Genelec 8010 speakers by chance?

A: The distance between the holes in the horizontal position is 4 inches. As for distance between the holes on the vertical end, the top hole distance is 1 1/2" while the bottom hole distance is 2 3/4". Unfortunately, this plate hasn't been tested with the Genelec 8010 speaker to our knowledge, so your results may vary.

Q: 7. will this spigot fit into my PhotoFlex LS-B2320Y stand?

A: Sorry, I don't know. I use it in knuckles (aka gobo heads). They fit those perfectly, and let you use an 3/8 or 1/20-20 threaded attachments.

Q: 8. Where can I get the yoke?

A: The ARRI Manual Yoke with Spigot for Orbiter, B&H # ARL20034025, or the ARRI Pole-Operated Yoke with Spigot for Orbiter, B&H # ARL20036642, would be the yokes compatible for use with the ARRI Orbiter LED Light.

Q: 9. I Have Impact VC 500wln lights will this stand work with this light?

A: Yes any monolight than has a 5/8" receiver like the Impact VC-500WLN can work with this stand.

Q: 10. What is the best battery for powering this on location? Can anton bauer vclx or block battery operate this?

A: An example if a battery brick that can power this light is the Fxlion 620Wh 15/28/48V Lithium-Ion Mega Battery, BH # FXHP722448D. https://bhpho.to/36QCP4J