The LH-47LR Ball Head with LR-60 Lever Release Clamp from Leofoto is a low-profile head with an Arca-type quick release clamp and plate. The head features a 1.9" diameter ball and provides two drop notches for efficient tilt adjustment. It has separate locking knobs for the pan base, for tension adjustment, and for locking the ball in place. The mount type at the base of the head is a 3/8"-16 female thread. The pan base diameter is 2.4". The head's load capacity is 48.5 lb.

The lever release of the quick release clamp allows quick attachment and removal of the quick release plate. The quick release plate features a 1/4"-20 mounting screw.

Low-Profile Arca-Type System    Load Capacity: 48.5 lb    2.4" Lever Release Clamp    Dual Drop Knotches

Related Questions and Answers

Q: 1. Can I use this with the Ronin Sc?

A: You could probably adapt it but it will throw the weight and height of the camera off and calibrating it would be difficult if not impossible.

Q: 2. Can this LR Clamp 60 be installed on a Manfrotto XPRO Ball Head and replace the original 200 PL-14? I would like to switch to ARCA.

A: Yes.

Q: 3. Can this clamp be installed on FLM CB-58FRT ball head?

A: While it is possible to use this clamp on the FLM CB-58FRT, it has not been tested to our knowledge. Your results may vary.

Q: 4. Will this product fit to a Manfrotto 290 xtra Tripod?

A: Yes, it will fit.

Q: 5. What is the ball-tightening lever made of, plastic or metal?

A: The tightening lever of the Leofoto LH-25 Mini Ball Head is made of metal.

Q: 6. When you remove the included clamp, is there an orientation key to keep the clamp aligned?

A: Yes, there are orientation tabs.

Q: 7. Is the BH-25 the best choice for use on a platypod ultra? I plan on using it with my Olympus OMD EM1 Mk2 with a 12-40MM lens. Or should I step up to the BH-30 for this use?

A: The Really Right Stuff BH-30 Ball Head with Compact Lever-Release Clamp B&H # REBH30LR would be better to use with the Platypod Ultra since it has nearly double the load capacity of the BH-25.

Q: 8. Does this ball head include ball mounting bushing?

A: The Leofoto LH-55LR Ball Head with LR-70 Lever Release Clamp does not include a 3/8"-16 to 1/4"-20 Reducer Bushing. To mount the head to a tripod with a 1/4"-20 stud, get the Oben 3/8"-16 to 1/4"-20 Reducer Bushing, BH #OB1039.

Q: 9. Hi can i replace this with the one i have as knobe on ballhead55!?

A: You have to use the RRS BH-55 ballhead. I am using the 80mm clamp and it is much more positive than the Arca Swiss.

Q: 10. Can it be used to replace the ball head on a Peak Design travel tripod?

A: Yes, the Really Right Stuff BH-25 Ball Head with Lever-Release Clamp can mount onto a Peak Design Tripod as long as the tripod is attached with a 3/8"-16, which most are.