The SSB-9 Counterweight Holder from ARRI offers two methods of using separately available CW-1 or similar counterweights to help balance your TRINITY 2 or 360 EVO stabilizer. Fasten the counterweights to the SSB-9 and then adjust the SSB-9 on a SAM plate to finesse the stabilizer's balance. You can also mount two SSB-9 holders to a SAM plate using 3/8"-16 screws to get the option of adding a second SAM plate, enabling you to position your camera slightly higher with the 360 EVO's inner ring.

For SAM Plate and CW-1 Counterweights    Use to Balance TRINITY or 360 EVO    Option to Use 2x SAM Plates for 360 EVO    Dovetail and 3/8"-16 Screw Mounting

• CW-1 and similar CSS counterweights
• SAM plates
• TRINITY 2
• 360 EVO

Related Questions and Answers

Q: 1. are the weights removable?

A: Yes, the center screw can be removed from the Tilta 15mm Counterweight allowing you to remove weight from the counterweight.

Q: 2. Is this counterweight compatible with the DJI RS4?

A: Yes, the DJI R Roll Axis Counterweight Set is compatible with the DJI RS4/RS4 Pro Gimbal Stabilizers.

Q: 3. Does this also fit the X9Air gimbal? It ships with a dummy plastic plate that appears to have a similar hole pattern.

A: Yes DJI Zenmuse X9 Counterweight will work with the DJI Zenmuse X9 air as well.

Q: 4. For the compatibility section, these are compatible with SAM-6 plates too right? The section should be updated under compatibili

A: Yes, the ARRI SSB-9 Counterweight Holder is compatible with ARRI SAM-6 plates as well.

Q: 5. Are the weights a 1/4" thread? I was thinking of buying this for the clamp so I could put a cold shoe mount on it for attaching a shotgun microphone.

A: Yes, the DJI counterweights have a 1/4"-20 thread.

Q: 6. Can it balance Sony Alfa 1 with sony 70-200 lens or 100-400 lens using counter weight

A: Yes it can.

Q: 7. Is the threaded connection on the bottom 5/8" ? I didn't see it listed on the product page.

A: the bottom of this boom arm is designed to fit into an existing mic stand, the 5/8" thread listed is at the top on the boom arm, to allow for industry standard a mic clip/holder for a microphone.

Q: 8. Can you purchase the screws to attach this to the camera separately?

A: Yes, you can easily source M3-6 Countersunk Screws online for use with the DJI Zenmuse X9 Counterweight. Four of them come with it, so this may not be necessary.

Q: 9. Will this work for the new DJI Ronin RS3?

A: According to DJI the DJI R Roll Axis Counterweight Set is not compatible with the RS 3 Pro but it is compatible with the RS 3. See: https://dl.djicdn.com/downloads/DJI_RS_3/DJI_RS_Series_Universal_Accessories_List_en.pdf

Q: 10. Above what lens weight is this needed for the Ronin 4d? Is it needed for the Cooke SP3 lenses?

A: DJI does not list a specific lens weight that the DJI Zenmuse X9 Counterweight is necessary for, but recommends the counterweight when using larger lenses that may be more difficult to balance.