This Provider Series Handheld Wireless Adapter Cable for Bodypacks takes your favorite wired dynamic handheld microphone and makes it wireless. This item will turn your mic into a wireless mic, compatible with Shure bodypacks, providing you with the freedom to roam around stage, without worrying about snagging your audio cable. No more long messy mic cables holding you back. This version is terminated with a TA4F connector for most Shure wireless beltpacks.

3' Cable

Related Questions and Answers

Q: 1. does this fit sony mdr7506?

A: Yes, this adapter would fully fit the 7506's.

Q: 2. Is possible use with Neumann kk205 and ulxd shure??

A: No, the Ambient Recording HHA-SSH Handheld Microphone Adapter is not compatible for use with the Neumann KK 205 Microphone Head and Shure ULXD2 Handheld Wireless Transmitter.

Q: 3. Are there external antennas?

A: Only on the belt pack. The receiver and handheld mic have internal antennae.

Q: 4. Will this adapter allow you to put a KK105 Cap on a Shure ADX2FH Handheld?

A: Thank you for your question. This adapter cap will allow you to connect a Neumann/sennheiser wireless capsule to the Shure ADX2FH handheld.

Q: 5. Shure BLX 1288/CVL-J10 is this rack mountabled??

A: No it isn't. I used a 1U rack shelf and used command strips to secure it.

Q: 6. Are these Mics UHF?

A: Yes. These microphones are UHF operating at 584 - 608 MHz

Q: 7. Am I reading correctly that this system can support both mics transmitting at the same time/same channel?

A: This system features a dual receiver, so both mics can operate at the same time, but they have separate outputs, which would go into two channels of a mixer. The Samson Concert 288 All-In-One Dual-Channel Wireless System (H-Band, 470 to 518 MHz), BH #SASWC288ALLH does offer a mixed output, if you require a single output to your mixer or portable speaker.

Q: 8. Is there a version of this system with lav mics? Can you mix and match?

A: The Shure BLX188 is the version with lavalier mics. Yes you can use 1 handheld mic transmitter and 1 lav beltpack transmitter with the receiver in the same frequency band.

Q: 9. Is the 1/4' output labeled Instrument out a line level output?

A: The manual shows the 1/4 inch output as -13 dBV into a 100K ohm load. With consumer line level at -10 dBV it's close but not quite line level.

Q: 10. What is the appropriate connector to go from this to the 3.5mm mic input of my Cannon vixia g50?

A: To connect the output from the Shure A15LA Line Adapter to the mic input on a Canon Vixia HF G50 Camcorder, you will need a cable with XLR 3-pin female and 3.5mm TRS male connectors like the Kopul XRSM 3-Pin XLR Female to 3.5mm RA Stereo Mini-Plug Cable - 1.5' (B&H # KOXRSM015B) or any similar cable with these connectors in the length you prefer.