Your 30mm riflescope will stay securely in place on your gun with this set of Scope Rings with Q-LOC Technology from Trijicon. Designed for scopes with objective lenses up to 44mm, the 6061-T6 aluminum rings mount on a Pictinny rail with one hand and with no tools required. The spring-loaded dovetail exerts 12-16 inch-pounds of torque—enough to hold the ring in place and retain zero—even without tightening the knobs. (The knobs can be tightened to 30-38 inch-pounds.)

Height Above Rail: 1.1"    For Objective up to 44mm    6061-T6 Aluminum Construction    Spring-Loaded for Constant Retention    No-Tools, One-Handed Mounting    Mounts on Picatinny Rail    Made in U.S.A.

• Made in U.S.A. from 6061-T6 aluminum
• Mounts on Picatinny rail with one hand, no tools required
• Spring-loaded clamps with 12-16 inch-pound torque will hold rings in place even if knobs are not tightened
• For riflescope with objective lens up to 44mm

Related Questions and Answers

Q: 1. Does this work on the Sanken CS-3e on a Sony FX3?

A: Yes, the Sanken ROCS Rubber O-Rings cam be used with the Sanken CS-3e Short Shotgun Microphone and Sony FX3 Cinema Camera.

Q: 2. How tall is the inside of the box? That is, how thick a stack of materials will it hold and still close properly?

A: The inner height is 47mm or 1-7/8 .

Q: 3. do this item fit with page #PR3576100Q for 35mm film ?

A: Yes it does easily with the negative storage pages

Q: 4. How exactly do you use these? Do you put one on the mic or multiple? I find no instructions on using them.

A: They go one on the top of the other till the microphone fits properly inside the camera mount/shock mount you trying to use the microphone with.

Q: 5. Is there a pocket on the outside for a label or other way to ID contents?

A: No, you can use an adhesive label.

Q: 6. Will these pages fit in the box? https://www.bhphotovideo.com/c/product/42995-REG/Print_File_PF357BXW100_Archival_Storage_Page_for.html/specs

A: They are recommended for that binder.

Q: 7. What is the depth of this box?

A: It's exactly 2 inches!

Q: 8. I read this will not fit a 6x6 36 roll. What binder will do this without curl or shooting less frames?

A: I would recommend the Print File binder that is over sized. You can click on the link below to view; https://www.bhphotovideo.com/c/product/915941-REG/print_file_215_0050_gbb12112_metal_edge_box.html

Q: 9. Is this made out of polypropylene plastic?

A: Yes, this binder is made from pure archival polypropylene.

Q: 10. Can this fit with Print File 35-7BXW?

A: Yes, but Print File 35-7BXW sheets fill the archive box completely. The plastic area of the archive sheets with the binder holes tends to get bent a little. The sheets are made of flexible plastic and bend near the binder rings. However, this does not affect the negatives in the archive sheets which lay flat.