This 6" long Universal Speedball Monitor Arm from MID49 provides two articulating points and allows you to easily yet securely position a monitor or other accessory. The system is compatible with the MID49 1" ball attachment system, as well as any third-party 1" ball system, such as Wooden Camera, Ultralight systems, and others. Each ball end contains both mounting thread standards, 3/8"-16 and 1/4"-20. To access the 1/4"-20, you push the 3/8"-16 outer thread down to reveal the hidden 1/4"-20 screw. The clamp design allows for easy installation, and the spring-loaded locking T-Bar can be pulled out and repositioned for tightening or loosening.

Combination 1/4"-20 & 3/8"-16 Screw    Cam-Lever Locking Design on Each End    Compatible with Standard 1" Ball Systems    Spring-Loaded Locking T-Bar

Related Questions and Answers

Q: 1. what is the mounting bracket size restrictions? I have a desk that is 3" thick

A: For the Uncaged Ergonomics Computer Monitor Arm Mount with USB Ports BH #UNMMB, this monitor arm mounts to your desk via the included C-Clamp or Grommet Mount. The C-Clamp is adjustable to fit a range of desktop thicknesses. At the widest setting, the opening is approximately 3 1/8".

Q: 2. Is it possible to place a hollyland mars 400 wireless receiver in between the monitor and the v mount plate ?

A: Unfortunately, there isn't enough space to fit a wireless transmitter between the monitor and V-mount plate.

Q: 3. Does this tilt monitor work with ikan DH7 7" Monitor ?

A: This bracket is designed for the Focus 7. The DH7 may work as well, as it does have a 1/4"-20 threading on the side of it. However the combination of this bracket and the DH7 is unknown at this time, it would have to be something one would test out to see the results. It may be possible though.

Q: 4. Does this work with smallhd focus 5 monitor ?

A: yes it will

Q: 5. Will an Odyssey 7Q+ fit on this?

A: Yes, The Proaim director's monitor cage would support displays like the Odyssey 7Q. It will support monitors from 4 to 7 inches.

Q: 6. Will this bracket work with the SmallHD Indie 7?

A: Yes it will.

Q: 7. What's the spec and what's the spacing measurement between those holes?

A: This monitor arm would have a VESA mount of 3 x 3 (75 x 75mm) and would have a step up plate to allow you to use it on a VESA mount of 4 x 4 (100 x 100mm).

Q: 8. Does this arm have a 1/4" screw hole in the base?

A: no this does not have a 1/4-20 female thread on the bottom

Q: 9. Does the Monitor fit into the case as well or is it just for the accessories?

A: The Atomos Universal Accessory Kit for 5 and 7" Monitors/Monitor-Recorders' included HPRC Hard Flight Case is designed just to support the accessories of the kit, a monitor will not fit inside the case along with the accessories.

Q: 10. How much friction is on the pivot joints? Is it easy to swing into position?

A: Just the right amount of resistance is present to move the arm but not so much that it swings out of position too easily.