Keep your light or accessory securely in place with the Flexible Gooseneck Arm with 1/4"-20 & Wall Mount from CAMVATE. This is a 12" flexible arm with a top 1/4"-20 male thread connector. Tapping screws are included to attach the arm's round base to a table, wall, ceiling, or other flat surface. Alternatively, the gooseneck arm has a 5/8" receiver that accepts a pole with a maximum 16mm column diameter. You can flex this aluminum/copper arm in a variety of angles to easily position your accessories or compatible devices.

12" Long Flexible Arm    For Mounting Lights & Other Devices    Attaches to Wall, Ceiling & Table    Round Base with Four Fitting Holes    Top & Bottom 1/4"-20 Mounting    Aluminum & Copper Construction

Related Questions and Answers

Q: 1. Is this too heavy for a manfrotto 1052bac?

A: It is compatible but if you use it extended it might tip. And in general I would use it with a sand bag.And if you do you should use it with another grip.Note that an arm like that is not made for heavy items like studio strobes. It is really made for cards, gobos and smaller lights like speedlights.For heavier items it is best to use a boom. And those can be boom arms, boom kits or boom stand combos. But the boom arms you should use a heavier and stronger stand.

Q: 2. Will the diameter of the arm fit into a standard umbrella swivel adapter?

A: The diameter of this arm would be too large to fit the umbrella slot on a standard umbrella swivel adapter.

Q: 3. Can the clamp at the end be removed and if it can what type of screw does it have on that side? For mounting on a hanlde.

A: No, the clamp can not be removed. It is attached to the goose neck part.

Q: 4. Its the included grip fixed to the end of the pole? Or can it be removed or moved to balance the pole??

A: The grip is fixed and can't be removed/moved.

Q: 5. Hello, if we get this mic, do i need anything more to install it on a table?

A: I installed it in a podium. I had to drill a hole to install the insert for the mic and ran the cable underneath. The mic then plugs into the cable when you put it in the holder.

Q: 6. Does this fit RX100 vi?

A: Yes, this would mount and be an appropriate tripod for the RX100-series cameras.

Q: 7. How much weight will a grip arm support ?

A: It depends on the orientation of the arm and clamps. It is a solid steel rod. In many cases it will exceed the load limit of a stand.

Q: 8. How much weight can this support? Looking to mount a Atomos Ninja Flame with 2 heavy batteries, curious if anyone has tried this?

A: I have this and I attached my small HD Focus monitor with one NPF battery. It does NOT hold up. The images on the box suggest that you can twist the arm for more support but I haven't found a way to do this. The arm will hold on it's own but as soon as I start walking around with my Crane 2 the arm fails.

Q: 9. is this just an arm or an arm with a head?

A: If you are looking at item Impact KCP240 40 EXTENSION GRIP ARM B&H# IMKCP240 : Mfr# KCP240 then that is JUST an arm. If you would like to mount this to a stand then also get Impact KCP200 2.5 GRIP HEAD (CHROME) B&H# IMKCP200 : Mfr# KCP200 . These are good products and I have two sets of each. I hope B&H pays me handsomely for working on their behalf.

Q: 10. What's the weight of the grip arm.?

A: The Impact 40" Extension Grip Arm (Black) weighs 3.25 lb / 1.47 kg.