Mount your GF-Slider just above the floor using this Leveling Leg from Grip Factory. This durable metal adapter is designed to mount onto one of the standard end mounts, and it provides a dual-leg setup for one end to set your slider just above the floor. Each of the small legs can be height-adjusted using the screws to level on uneven surfaces. Pair it with a second leveling leg end for the other end of your GF-Slider to complete your floor setup.

Mount GF-Slider onto Flat Surface    Mounts onto Standard End Mount    Raises Slider Height above Floor    Height Adjustment on Each Leg    Durable Metal Construction

Related Questions and Answers

Q: 1. What’s a good way to mount this onto some kind of dolly? What accessories are needed?

A: A bazooka with a Mitchell Mount or Bowl adapter is required to mount the Grip Factory Baby Jib Set with Accessories and Transport Case to a dolly.

Q: 2. In specifications says only 8lbs weught capacity is that correct?? The same stand on Mathhews says 25lbs is this a typo error or thats just the weight limit of just 8lbs?

A: The load limit according to the manufacturer is 8.8lb.

Q: 3. How do I attach a camera to this stand?

A: That is a light stand and is not recommended to be used as a tripod. To support a camera it is best to use a tripod. This should work a href= http://bit.ly/1LEWd32 target= _blank http://bit.ly/1LEWd32/a but again it is not recommended.This link the stand comes with a built in camera platform so you can get a tripod to fit on it, a href= http://bhpho.to/1LEXrLA. target= _blank http://bhpho.to/1LEXrLA./a

Q: 4. What is the lowest working height on this?

A: Minimum height 3.6'.

Q: 5. Do the avenger wheels that you offer fit this stand? Don't see the gauge of the stand tube in specs to cross compare with wheel specs...

A: The Avenger A9000NB Wheel Set, B&H # AVA9000NB will fit this stand.

Q: 6. Is this aluminum stand sturdy enough to mount an Aputure 600 series? Specs say it would hold the weight but curious if it would be awkward/wobbly at all?

A: Yes. With no problem the following unit offers a payload system of 60 lbs.

Q: 7. Is there a wheel kit for this stand?

A: These are the wheels the manufacturer calls for https://bhpho.to/3bAPnNW.

Q: 8. What type of case would you use to carry/transport these stands?

A: The Impact Lowboy Steel Stand with Leveling Leg and Combo Head (6.5') can fit into many bags/cases This is a few of many options, https://bhpho.to/3nc6FeF .

Q: 9. What is the weight?

A: As per the specifications, the weight of this stand is 7.72 lbs.

Q: 10. Can the stand be broken down to a short length so that it can fit in a normal car trunk?

A: If you are mechanically minded shortening the tripod into two sections is easy. Use a 4 mm allen tool to loosen the allen screw (each section has an allen screw and thumb screw) this will allow you to remove that section from the main tube of the tripod body. An aluminum flange will drop out when the allen screw is loosened, this flange is what secures, with the tightening of the allen screw, the section to the main tube, don't lose this metal tab. The tripod broken into two pieces will fit in an average trunk. To reset the flange for reassembly is is easiest to tilt the tripod down and let gravity slide the flange back in the slot then screw the allen back in tight.