Ideal for distributing RF signals and low-power video signals such as component and composite, the 50' RG59 Coaxial Cable from Williams Sound is preterminated and ready for installation. The cable sports a typical 75-ohm impedance.

Preterminated Coaxial Cable    For Low-Power Video and RF Signals    Supports Composite and Component Video    75-Ohm Impedance

Related Questions and Answers

Q: 1. Can this be used to travel I plan on being on a ship I do have hearing aids but lots of back ground noise can anyone help me?

A: Travel with this kit is easy. Every thing is together in one portable case. The alkaline battery selection gives you twice the hours as the rechargeable type and there is no charger to transport. AA batteries are available everywhere. I use the MIC 014 omni-directional microphone and place the transmitter in the center of the room or table. Everyone is facing the unit and clarity is enhanced over my hearing aids. With the MIC 014 range is decreased to about 25 ft radius but adequate for a large room.

Q: 2. Is this receiver compatible with the Williams PPA T17 transmitter?

A: Yes, this R 37 receiver is compatible with the older T17 transmitter from Williams Sound. Both are Wide Band units in the 72-76 MHz frequency for full rich sound clarity.

Q: 3. Does the receiver in this bundle come with an antenna?

A: Yes it does. The ANT 025 whip antenna is included.

Q: 4. Where can I find a longer one?

A: Lance G.'s answer looks correct, except a stereo 3.5 mm female to 3.5 mm male cable also works well and may be easier to find. Have used one for years.

Q: 5. can this be used in a drive up movie set up through car radio's?

A: This transmitter will not work with car radios.

Q: 6. How many headset can be run off (connected) to a single transmitter?

A: Each receiver has only one headphone jack

Q: 7. This neck loop is compatible with what Williams sound devices?

A: I use the Neck Loop with a Williams PPA R35E Personal receiver. It has a mono plug.With a mono to stereo adapter it can be used with portable FM Receivers and I also plug mineinto a Bluetooth receiver to listen to Bluetooth devices through my hearing aids.It is a great device to enhance the use of my hearing aids with the telephone switch.Roy

Q: 8. is there a transformer available?

A: Williams Sound TFP008 - 110VAC/12VAC Power Supply for T27, IC-1, TEL040 B&H # WITFP008

Q: 9. Specs are not listed here. What items are in the box? Charging cord? Rechargeable batteries?

A: This item is just an extra receiver for an existing Williams Sound Digi-Wave 400 Series system. It has a built-in rechargeable battery and would be compatible with the Williams Sound CHG 412 charging dock.

Q: 10. Does this system do the interpretation via a software?

A: No, the Williams Sound Digi-Wave 400 Interpretation System for 1 Presenter and 10 Listeners does not interpret speech automatically. This device is used for a live interpreter to speak to select listeners.