Add six outlets of surge-protected power to your SmartMount Flat Panel Cart SR860 or SR898 with the Peerless-AV ACC148 Surge Protector. The ACC148 includes a 15' power cord and mounting bracket to conveniently attach to your cart.

For Use with SR860 & SR898    6-Outlet Surge Protector    15' Power Cord    Mounting Bracket Included

Related Questions and Answers

Q: 1. Will this mount fit an Optoma EH412ST projector?

A: Yes - but please note: To use this mount, purchase a separate custom Peerless PAP Adapter Plate made for your model projector.

Q: 2. Can this mount be used outside and will it work with a Q-See camera

A: While the mount can be used outside, I would make sure that the camera you are connecting is outdoor rated.

Q: 3. Can I use this for 1 Samsung CHG90 monitor?

A: Peerless-AV Desktop Stand for Two 24 to 49" Ultra-Wide Monitors (BH # PELCT650SD)is compatible with the Samsung CHG90 49" 32:9 Curved 144 Hz FreeSync HDR LCD Monitor (BH # SAC49HG90).

Q: 4. Is this compatible with the Panasonic FRZ50?

A: The Peerless-AV PRG Precision Gear Projector Mount for Projectors Weighing Up to 50 lb (Black) BH #PEPRGUNV will work with the Panasonic PT-FRZ50WU 5200-Lumen WUXGA Classroom & Office Laser DLP Projector (White)BH #PAPTFRZ50WU.

Q: 5. I just bought a Projector with mounting holes that are 8 apart. I have an existing threaded shaft attached to the ceiling but the plate on it is to small. Can i replace my plate with this and will it extend to 8 ?

A: The mount is adjustable to fit many kinds of projectors. Ours holds a HD photo grade projector that is very large and heavy and it works fine. 8 inches should be no problem. I can't be sure about the plate your talking about but even the top mount is adjustable to fit a variety of brackets and braces so it should work.

Q: 6. What is the Equipment Protection Policy on this?

A: Ubiquiti is a well known company for making very high qualty, dependable products that perform as specified. the product itself comes witha 1-Year Warranty Product data sheet link here: https://dl.ubnt.com/datasheets/ETH-SP/Ethernet_Surge_Protector_DS.pdf

Q: 7. What Voltage and Amperage ratings does this strip have? e.g., 125V 15A, etc.

A: It's your lucky day (or night)! I happen to be an electronic engineer. After digging around for a while, I found that the strip is rated 15 Amps at 125 volts. That means you can plug one 15 amp load or three 5 amp loads. In other words the TOTAL load ON THE WHOLE STRIP cannot exceed 15 amps. Hope this answer helps.

Q: 8. Could this be mounted to a wall?

A: Not as far as we know.

Q: 9. my post from my projector is 2" the specs says it goes up to 1 3/4" can I just buy longer clamping screws?

A: You would need to contact Peerless AV directly or check local home improvement or hardware stores. Peerless-AV Tel: (630) 375-5100 or (800) 865-2112 Email info@peerless-av.com

Q: 10. What is the maximum amp rating?

A: I am asking about total current draw through the entire device - all the outlets combined. I am guessing 15 Amps, based on no information except that most cube taps are 15 amps maximum.