Get your racing drone back in the sky with this pair of Hawk Apex Drone Arms from EMAX. These 3.5" arms can be used to replace damaged parts on your existing Hawk Apex, or you can use them to build one from scratch with an optional mid plate and other essential hardware.

For EMAX Hawk Apex Drones    Replace Damaged Arms

Related Questions and Answers

Q: 1. Do these have a flat side?

A: Yes these spigots have a flat size.

Q: 2. Is it possible to hold it only with the tightening function built in Profoto A1?

A: Being that the Profoto A1 is a shoe mount flash, it can be held on this Manfrotto shoe adapter with the tension built into the foot on the flash itself.

Q: 3. It is not clear from the single photo of this adapter how it attaches to the 244 friction arm. My 244 arm has a standard 5/8" spigot on each end. So how does this adapter connect to a spigot - does it fit over the spigot and set-screw tighten? or is there a 1/4" or 3/8" thread somewhere?

A: Via 1/4 opening.

Q: 4. Does this fit directly into the thread provided on the back on the MOZA Air 2?

A: This arm has 1/4"-20 screws. The Moza Air 2 has a 3/8"-16 threaded hole on the front of the handle and 1/4"-20 and 3/8"-16 threaded holes on the bottom. You could use this arm on the bottom of the gimbal as is. To use it on the front handle you will need a 3/8"-16 to 1/4"-20 Reducer Bushing, BH #OB1039. https://bhpho.to/2gGw2Pp

Q: 5. Will these work with a ARRI BSA-1 Broadcast Shoulder Adapter? The Rossette handle I have now wont because the screw is too long

A: The Tilta Professional Handgrip Side Arms (Pair) should fit on the ARRI BSA-1 Broadcast Shoulder Adapter since they have ARRI Rosettes, but for the best compatibility, we would recommend the ARRI Handgrip without On/Off Switch, B&H # ARK2.47861.0, with the ARRI Long Handgrip Extension (7.7"), B&H # ARK2.47863.0.

Q: 6. Can you purchase extra LI batteries for this drone? Do you sell them?

A: Unfortunately we do not carry replacement batteries for the Snaptain SP700 Quadcopter Drone. For replacements parts, please reach out to Snaptain support.

Q: 7. Can you tell me the width inside and outside the "fork"? Want to use on different brand arm I already own. Tks!

A: These dimensions for the K&M 23881 5/8" Adapter for Monitor Mount Arms, BH # KMAMMB, are not published by the manufacturer. The outside is about 2.1" and the inside is just less than 2".

Q: 8. How do the light arms attach to the copystand? Is it a clamp or a permanent mounting bracket that is affixed to the stand?

A: Will this also work with the 47 Motorized Kaiser 205603?

Q: 9. Is the 15mm rod support the same spacing as the Blackmagic URSA built-in 15mm rods? Will this support the URSA's weight?

A: Yes, I use it with the ursa

Q: 10. Does anyone know if the wooden BMCC grips offered by tilta will attach to these handles?

A: These Universal Handgrips are compatible with the Tilta TT-0507 Wooden Handles as they both use Arri Rosettes