The Aluminum Baby Boom Stand by Kupo is a travel-friendly and versatile stand that provides great support on the field or in the studio. The stand is designed to support up to 19.8 lb and can be converted into a two-section boom thanks to a secondary riser pivot that allows you to mount lights up to 4.5 lb. The boom's adjustable length extends from 43.7 to 75.2", and an empty sandbag is included in the package to provide counterweight support. Additionally, it features a dual 5/8" baby receiver with a detachable baby pin on the stand top, allowing you to connect lighting fixtures, softboxes, and other equipment, and includes two cable clips to better organize your setup.

Maximum Extension of 75.2"    Dual 5/8" Baby Receiver and Baby Pin    Stand Supports up to 19.8 lb    Two-Section Boom Supports up to 4.5 lb    Includes Empty Sandbag and Cable Clips    Aluminum Build

Related Questions and Answers

Q: 1. How much weight can this hold? Looking to support an AD200 with a medium sized Godox umbrella with diffuser.

A: Hi Stephanie, While Kupo does not provide a load rating on this model, a lightweight fixture like the AD200 with an umbrella will be fine mounted to this arm.

Q: 2. If this extension is used to connect a tether table to a runway stand base, will the setup be sturdy enough to use a laptop safely or will the whole thing be too wobbly?

A: It would depend on how you attached it but it could work if you want your laptop 2 feet off the ground.

Q: 3. Is the lower end blocked? Can I connect using a long stud so that the extension and the lower stand makes direct contact?

A: The is no hollow hole from the end to end in Kupo Baby Stand Extension (18"). On some baby pin 5/8 you won't be able to place to completely down in the pin.

Q: 4. Why is its weight not listed in the SPECS?

A: As a metal rod extension the Kupo Baby Stand Extension (24") BH #KUKG019512, it would be the stand limits that would be more the determining factor.

Q: 5. Do the locking pins dig directly in the poles or is there a metal "brake" for better grip and less damage to the pole?

A: There is a brake between the pole and the collar to add friction and prevent damage to the pole.

Q: 6. Which Kupo Brake Caster fits this stand?

A: The manufacturer does not list any casters for the Kupo High Baby Stand (13.75') BH #KUKS101112.

Q: 7. How does this attach to the light stand? I can't tell from the pictures. Is there another part to purchase to connect the boom to, for example, C-stand?

A: You would use a grip head (Kupo's term), basically a special vice with a stand receptacle. The boom's slotted plate slides into the grip head, which then attaches to a normal stand's stud.

Q: 8. Would this be a good stand for the Aputure 600d?

A: Yes, the Kupo High Baby Stand (13.75') is compatible with the Aputure 600d.

Q: 9. How much weigh can this extender take?

A: The weight capacity would be dependent on the stand that the extension is used with.

Q: 10. Is the listed minimum height with the center column raised or lowered?

A: The Kupo High Baby Stand (13.75') minimum working height is 55.5" / 141 cm.