The Sennheiser Power Supply for TeamConnect Bar S is a replacement power supply for powering your TeamConnect Bar S. This essential accessory ensures reliable and efficient operation of the TC Bar, allowing for uninterrupted audio and video conferencing experiences.

For TeamConnect Bar S    Input Power: 100-240 VAC, 50/60 Hz    Output Power: 15 VDC

Related Questions and Answers

Q: 1. Will this keep a desktop computer up and running during a very short power outage, such as a one second outage that normally causes my computer to shut down? In other words, does it switch fast enough to the power supply to prevent shut-down of the computer?

A: Yes it will. Should work like a battery on a laptop. Depending on the usage and the size of the computer system it'll last averaging 45-60 minutes per charge on battery back-up status. Also it'll put it to sleep to conserve battery and whatever might still be running on the computer. Check your power settings after installing drivers Make sure to connect the usb and utility drivers. It's Power button must be on at all times for the backup baterry unit to work. Recommend not to connect printer as it pulls much more power and drain the battery.

Q: 2. How do I enter a gift card pin to buy and item?

A: Call B&H customer service...

Q: 3. Does this work for the receiver component too?

A: How can i eliminate the buzz noise ? A lot of forum talk about it but no answer...

Q: 4. Can I run the output into an unbalanced recorder?

A: No problem - just adapt the XLR output from the ROLLS to the required input on your recorder.

Q: 5. Can I use this to power an Evolution mount, for when the mount's own internal battery gets low?

A: It has 1 x 12 VDC Celestron telescope power port Which is a car DC plug output is 12 volts

Q: 6. Does this unit work with the G4 series transmitters as well?

A: I verified with the manufacture and yes it does work with the Sennheiser G4 transmitter series

Q: 7. will this work with ? 1.skywatcher HEQ5 2. ZWO 1600 mono cooled 3. ASI 120mm - s 4. 2 dew shields

A: The PowerTank Lithium is compatible with the Sky-Watcher HEQ5. You will need to contact the other manufacturers for compatibility inquiries. Sincerely, Garrett at Celestron

Q: 8. I understand that this unit will automatically & safely shutdown a QNAP NAS during outage. Is it possible for it to also shut down my mac computer automatically?

A: Yes, this operation can be configured using the PowerPanel® Personal Mac software from CyberPower, compatible with MacOS 10.14 and above. The software is available at this link: https://bit.ly/3OMzsPu

Q: 9. the info states Balanced XLR-female, x6 and Balanced 1/4 TRS Phone, x6 . Picture shows Balanced XLR-female, x6Balanced XLR-male, x6. which is it?

A: When in doubt, trust the photo. There are only XLR jacks on this piece of gear. no 1/4 inputs, or outputs.

Q: 10. Can I add a non Condenser mic and just use one of the port as a pass through no phantom power required?

A: No you can't. This is an active device it is always passing current whether you use phantom or not. If you plug a dynamic into it the capsule will burn out in time.